AS-i base Dimensions 80 36 26 18.5 45 18.5 O 9.6 36 Model number U-G1FA Base with addressing jack for connection to flat cable (EMS; AS-i only) The U-G1FA base allows slaves in the normal design to be connected to AS-i without additional supply (EMS) . It has two connections to AS-Interface, which are interconnected. Thus it can also be used as distributor from one AS-i segment to another. When mounting the upper part (module or cover VAZ-DK-G1) the flat cable are pressed in the contact prongs and thereby connected. General specifications Addressing Ambient conditions Ambient temperature Storage temperature Mechanical specifications Protection degree 22.01.2002 Ausgabedatum via addressing jack -25 ... 60 C (248 ... 333 K) -25 ... 85 C (248 ... 358 K) IP67 based on EN 60529 (only in connection with module or cover) 2 AS-i flat cables about 80, 45, 20 mm (L, W, H) top hat section rail or screw mounting Electrical connection AS-i AS-i + - + - Addressing jack + - Contacts to module Accessories Moreover, an integrated addressing jack can configure the upper part in the wired AS-i network. In this case the controller indicates Alarm Config", since the slave is disconnected from the supply. After removing the addressing plug, the controller restarts independently. O 5.3 Technical data Connection type Dimensions Mounting Function 26 Accessories VAZ-DK-G1 Cover for bases -G1F- and -G1P- Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group * Tel.: Germany (06 21) 7 76-0 * USA (330) 4 25 35 55 * Singapore 7 79 90 91 * Internet http://www.pepperl-fuchs.com 338