PFE300-1000 Series 300 to 1008W AC-DC Power Module Features u Low profile, small size u 100C baseplate temperature u High power density u High Efficiency u Suitable for conduction cooling u Power Factor Corrected (PFC) Key Market Segments & Applications Specifications Model AC Input VAC Input Current (100 / 220VAC) A Model dependant Inrush Current (100 /200VAC) (1) A Power Factor Output Voltage Setpoint Accuracy Ripple and Noise (1) Over Current Protection % Over Voltage Protection Series Operation Parallel Operation Power On Signal (ENA) Auxiliary Supply Remote On/Off (Opto isolated) Overtemperature Protection Operating Baseplate Temp. C Storage Temperature C Humidity (non condensing) Cooling Withstand Voltage (1 min) (3) Isolation Resistance Vibration (non operating) Shock Safety Certifications Weight g Size (WxHxL) mm in Warranty yrs PFE300S PFE500S PFE700S 85 to 265VAC, 47-63Hz (up to 440Hz) (4) 8.8 / 4.4 6.8 / 3.4 4.0 / 2.0 6.2 / 3.2 2% 1% PFE500F 20 / 40 peak 0.95 minimum, meets EN61000-3-2 1V 2% 4V 1% 105 - 140% (Automatic Recovery) 125 - 145% 60 - 69.6V 125 - 145% PFE1000F 13.6 / 6.6 2% 1% 105 - 140% Manual reset 125 - 145% Yes No Yes (Droop mode) Yes (Single wire) Yes (Single wire) Open collector (10mA sink current). Low (on) when output is present None None 10 - 14V, 20mA 10 - 14V, 20mA None None High = On High = On Yes -40 to +100C (2) -40 to +100C Operating: 20 - 95%RH, Non Operating: 10 - 95%RH Conduction Input to Output 3kVAC, Input to Baseplate 2.5kVAC, Output to Baseplate 1.5kVDC Output to baseplate: 100M Ohm at 500VDC, 25C ambient, 70%RH 10-55Hz (1 min sweep), constant amplitude 0.825mm (max 49m/s2), X, Y, Z 1 hour each 196.1m/s2 UL60950-1, CSA60950-1 (cUL), EN60950-1, CE mark (LVD) 250 250 300 500 61 x 12.7 x 116.8mm 70 x 12.7 x 122mm 100 x 13.4 x 160mm 2.4 x 0.5 x 4.6" 2.76 x 0.5 x 4.8" 3.94 x 0.53 x 6.3" 2 years Notes: (Consult Installation Manual for detailed specifications, test methods and application notes) 1) External components are required, consult Application Notes 2) PFE500S-12, PFE500F-12: -40 to 85C. See instruction manuals for derating curves PFE1000F28 & PFE1000F48: -40 to 85C below 170VAC input voltage. See instruction manuals for derating curves 3) PFE500F, PFE1000F: 500VDC Output to baseplate 4) Reduced PFC above 63Hz. Contact technical support for 440Hz operation. 1-800-526-2324 * www.us.tdk-lambda.com/lp/ 118 Disclaimer: us.tdk-lambda.com/lp/legal.htm PFE300-1000 Series Specifications Model PFE300S-12 PFE500S-12 PFE500F-12 PFE1000F-12 PFE300S-28 PFE500S-28 PFE500F-28 PFE1000F-28 PFE300S-48 PFE500S-48 PFE500F-48 PFE1000F-48 PFE700S-48 Output Voltage (V) 12 12 12 12 28 28 28 28 48 48 48 48 51 Adjust. Range (V) 9.6 - 14.4 9.6 - 14.4 9.6 - 14.4 9.6 - 14.4 22.4 - 33.6 22.4 - 33.6 22.4 - 33.6 22.4 - 33.6 38.4 - 57.6 38.4 - 57.6 38.4 - 57.6 38.4 - 57.6 None Maximum Current (A) 25 33 42 60 10.8 18 18 36 6.3 10.5 10.5 21 14 Maximum Wattage (W) 300 396 504 720 302 504 504 1008 302 504 504 1008 714 Load Line Reg. (mV) Reg. (mV) 48 48 48 48 48 48 48 48 56 56 56 56 56 56 56 56 96 96 96 96 96 96 96 96 50 - 57V (5) Efficiency typ (4) 81 / 83 82 / 83 81 / 83 80 / 82 83 / 85 84 / 86 84 / 86 85 / 87 84 / 86 84 / 86 84 / 86 84 / 86 86 / 89 (4) 100 / 200VAC. Efficiency valves at 115/230VAC are 1% higher. (5) Total regulation range PFE500S & PFE700S Outline Drawing PFE500F Outline Drawing 5.00.5 12.7 CL See note A See note D AC (N) AC(L) AC (L) PFE500F-48 -V +V 12.0 29.73 BAR CODE +BC +S TRIM +ON/OFF IOG -ON/OFF ENA AUX COM -S PC +ON/OFF -ON/OFF AUX +S TRIM IOG ENA COM -BC 2.54 R -S PC 2.54 EN6 0 9 5 0 2.54 AC-DC MADE IN JAPAN R +BC 2.54 -BC 2.54 9.93 59.70.5 70.00.5 12.0 5.78 CL -V +V INPUT:100-240VAC 8A 50/60Hz OUTPUT:48V 10.5A 5.78 AC(N) See note C 3.7 See note E 5.26 15.0 See note B 15.0 54.12 111.80.5 122.00.5 Lot No. seal PFE500S Basic connection Heatsink Table Heatsink HAF-10L HAF-15L HAF-15T HAL-F12T HAM-F10T Size (mm) 116.8 x 25.4 x 61 116.8 x 38.1 x 61 116.8 x 38.1 x 61 122 x 35 x 69.9 160 x 33.4 x 100 PFE Module PFE300/500S PFE300/500S PFE300/500S PFE500F PFE1000F Options Suffix Blank /T Description M3 tapped mounting inserts (4) 3.3mm non-threaded inserts (4) For Additional Information, please visit us.tdk-lambda.com/lp/products/pfe-series.htm 1-800-526-2324 * www.us.tdk-lambda.com/lp/ 119 Revision C6: Jun 2013