Specifications subject to change without notice. All dimensions in inches. © Copyright 2010 The Connor-Winfield Corporation
Environmental Characteristics
Shock 500 G’s 1ms, Halfsine, 3 shocks per direction, per MIL-STD 202G, Method 213B Test Condition D.
Sinusoidal Vibration 0.06” D.A. or 10G’s Peak, 10 to 500 Hz, per MIL-STD-202G, Method 204D, Test Condition A.
Random Vibration 5.35 G’s rms. 20 to 2000 Hz per MIL-STD-202G, Method 214,Test Condition 1A, 15 minutes each axis.
Moisture 10 cycles, 95% RH, Per MIL-STD-202G, Method 112.
Marking Permanency Per MIL-STD-202G, Method 215J.
Solder Process RoHS compliant, lead free. See solder profile on page 4.
Package Characteristics
Package Package consisting of a FR4 substrate and Ryton-R4 cover. Water Resistant, non-hermetic seal.
2111 Comprehensive Drive
Aurora, Illinois 60505
Phone: 630-851- 4722
Fax: 630- 851- 5040
www.conwin.com
Bulletin Cx207
Page 3 of 4
Revision 15
Date 21 Aug 2012
OCVCXO Input Characteristics (Optional)
Parameter Minimum Nominal Maximum Units Notes
Control Voltage Range: 0.30 1.65 3.00 V 6
Frequency Pullability: ±10.0 - - ppm 7
Input Impedance 100K - - Ohms
Linearity ±5 - - %
Recommended Cleaning Process
DOC Series Package Wash only in a inline high pressure wash station that has an air knife and drying capabilities.
(Drying temperature range from 85° to 100°C)
Notes:
1. Frequency stability vs. change in temperature. [±(Fmax - Fmin)/2.Fo].
2. Initial calibration @ 25°C. For OCVCXO control voltage must be fixed.
3. After 30 days of operation
4. Inclusive of calibration @ 25°C, frequency vs. change in temperature, change in supply voltage (±5%), load change (±5%), shock and vibration
and 20 years aging
5. Attention: To achieve optimal frequency stability, and in some cases to meet the specification stated on this data sheet, it is required that the circuit
connected to this OCXO output must have the equivalent input capacitance that is specified by the nominal load capacitance. Deviations from the
nominal load capacitance will have a graduated effect on the stability of approximately 20 ppb per pF load difference.
6. Positive slope. (Frequency increases as Vc voltage increases.)
7. Referenced to Fo.
Phase Noise Characteristics
Typical Phase Noise for DOC050F - 010.0M
Parameter Minimum Nominal Maximum Units Notes
@ 1 Hz offset - -67 - dBC/Hz
@ 10 Hz offset - -100 - dBC/Hz
@ 100 Hz offset - -130 - dBC/Hz
@ 1 KHz offset - -148 - dBC/Hz
@ 10 KHz offset - -154 - dBC/Hz
@ 100 KHz offset - -155 - dBC/Hz