60.8mm (2.4 INCH) 5x8 DOT MATRIX DISPLAY P/N: TA24-11GWA Features z2.4 Description INCH MATRIX HEIGHT. zDOT zLOW The Green source color devices are made with Gallium SIZE 5mm. zHIGH GREEN Phosphide Green Light Emitting Diode. CURRENT OPERATION. CONTRAST AND LIGHT OUTPUT. zCOMPATIBLE zSTACKABLE zEASY WITH ASCII AND EBCDIC CODES. HORIZONTALLY. MOUNTING ON P.C. BOARDS OR SOCKETS. zMULTICOLOR AVAILABLE. zMECHANICALLY zSTANDARD zRoHS RUGGED. : GRAY FACE, WHITE DOT. COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAD2471 REV NO: V.5 DATE: NOV/28/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: F.LI ERP:1332000200 Selection Guide Part No. Dice TA24-11GWA Iv (ucd) @ 10mA Lens Type GREEN (GaP) WHITE DIFFUSED Description Min. Typ. 3000 12000 Column Anode Electrical / Optical Characteristics at TA=25C Symbol Parameter Device peak Peak Wavelength Green D Dominant Wavelength 1/2 Typ. Max. Units Test Conditions 565 nm IF=20mA Green 568 nm IF=20mA Spectral Line Half-width Green 30 nm IF=20mA C Capacitance Green 15 pF VF=0V;f=1MHz VF Forward Voltage Green 2.2 2.5 V IF=20mA IR Reverse Current Green 10 uA VR = 5V Absolute Maximum Ratings at TA=25C Parameter Green Units Power dissipation 105 mW DC Forward Current 25 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage -40C To +85C Operating / Storage Temperature Lead Solder Temperature [2] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. SPEC NO: DSAD2471 REV NO: V.5 DATE: NOV/28/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: F.LI ERP:1332000200 Green TA24-11GWA SPEC NO: DSAD2471 REV NO: V.5 DATE: NOV/28/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: F.LI ERP:1332000200 PACKING & LABEL SPECIFICATIONS TA24-11GWA Remarks: If special sorting is required (e.g. binning based on forward voltage, Luminous intensity/ luminous flux, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity/ Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD2471 REV NO: V.5 DATE: NOV/28/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: F.LI ERP:1332000200