PRODUCT SPECIFICATION
.156 CENTER KK RPC
BOARD TO BOARD
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC
4.2 CURRENT (Current is dependent on connector size, contact material, plating, ambient
temperature, printed circuit board characteristics and related factors. Actual current rating is
application dependent and should be evaluated for each application.)
Amps (Max)
With Phos Bronze
Note: Current ratings above were determined with 2.54mm (.100 inch) wide 2oz. copper traces.
Ratings are for a single circuit, based on not exceeding 300C temperature rise.
4.3 TEMPERATURE
Non Operating Temperature
*including terminal temperature rise. Testing of the housing material to establish the maximum
operating temperature for the connector assembly at UL is in progress. The currently assigned
maximum operating temperature rating at UL is 65°C and is the default rating for the material.
This rating is expected to be increased to 105°C upon completion of the in-progress product
safety tests.
**parts not mated
5.0 PERFORMANCE
5.1 ELECTRICAL REQUIREMENTS
Contact
Resistance
(Low Level)
Mate connectors: apply a maximum voltage
of 20 mV and a current of 100 mA.
10 milliohms
MAXIMUM
[initial]
Contact
Resistance of
Wire Termination
(Low Level)
Terminate the applicable wire to the terminal
and measure wire using a voltage of 20 mV
and a current of 100 mA.
2 milliohms
MAXIMUM
[initial]
Unmate & unmount connectors: apply a
voltage of 500 VDC between adjacent
terminals and between terminals to ground.
Dielectric
Withstanding
Voltage
Unmate connectors: apply a voltage of {two
times the rated voltage plus 1000 volts} VAC
for 1 minute between adjacent terminals and
between terminals to ground.
Measure between adjacent terminals at 1
MHz.