Tyco / Electronics PolySwitch(R) PTC Devices Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 Fax: 800-227-4866 PRODUCT: VTP210GF DOCUMENT: SCD 25823 PCN: F56527 REV LETTER: B REV DATE: NOVEMBER 16, 2004 PAGE NO.: 1 OF 1 Overcurrent Protection Device Specification Status: Released Maximum Electrical Rating Operating Voltage: 16Vdc Interrupt Current: 100A A D Leads: Nickel 1/4H 0.125mm nominal thickness C E Solder: Lead-free B F Tape: Polyester (White) 13 mm nominal width R Lot Marking Ink Color (Green) ORIENTATION MARK(Blue) Marking: Manufacturer's Mark V21 Part Identification Lot Identification TABLE I. DIMENSIONS: mm: in*: A B MIN MAX MIN MAX 20.9 23.1 4.9 5.3 (0.82) (0.91) (0.19) (0.21) *Rounded off approximation C MIN --- D MAX 0.8 (0.03) MIN 4.1 (0.16) E MAX 5.8 (0.23) MIN 4.1 (0.16) F MAX 5.8 (0.23) MIN 3.9 (0.15) R MAX 4.1 (0.16) TYP 1.0 (0.4) MAX --- TABLE II. PERFORMANCE RATINGS: As measured in Mueller Kelvin Clips Model BU-75K I HOLD AMPS 25C HOLD 2.1 CURRENT TRIP LIMITS TIME TO TRIP REFERENCE RESISTANCE AMPS AMPS AMPS AMPS SECONDS AT OHMS AT 0C AT 25C AT 60C AT --C 25C, 10.0A AT 25C HOLD TRIP HOLD TRIP HOLD TRIP HOLD TRIP MIN MAX MIN MAX 2.9 6.0 2.1 4.7 1.0 2.8 ------5 0.018 0.030 Agency Recognitions: Reference Documents: Precedence: Effectivity: CAUTION: ONE-HOUR POST-TRIP RESISTANCE OHMS AT 25C MIN MAX 0.018 0.060 TRIPPEDSTATE POWER DISSIPATION WATTS AT 25C,16V MAX 1.5 UL, CSA, TUV PS300 This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. (c) 2004 Tyco Electronics Corporation. All rights reserved. (c) 2004 Tyco Electronics Corporation. All rights reserved.