R0201-BS62LV4003 Revision 2.0
April 2002
2
Name Function
A0-A18 Address Input These 19 address inputs select one of the 524,288 x 8-bit words in the RAM
CE Chip Enable Input CE is active LOW. Chip enable must be active when data read from or write to the
device. if chip enable is not active, the device is deselected and is in a standby power
mode. The DQ pins will be in the high impedance state when the device is deselected.
WE Write Enable Input The write enable input is active LOW and controls read and write operations. With the
chip selected, when WE is HIGH and OE is LOW, output data will be present on the
DQ pins; when WE is LOW, the data present on the DQ pins will be written into the
selected memory location.
OE Output Enable Input The output enable input is active LOW. If the output enable is active while the chip is
selected and the write enable is inactive, data will be present on the DQ pins and they
will be enabled. The DQ pins will be in the high impedance state when OE is inactive.
DQ0-DQ7 Data Input/Output
Ports
These 8 bi-directional ports are used to read data from or write data into the RAM.
Vcc Power Supply
Gnd Ground
TRUTH TABLE
PIN DESCRIPTIONS
BSI
MODE WE CE OE I/O OPERATION Vcc CURRENT
Not selected X H X High Z ICCSB, ICCSB1
Output Disabled H L H High Z ICC
Read H L L DOUT ICC
Write L L X DIN ICC
SYMBOL PARAMETER CONDITIONS MAX. UNIT
CIN Input
Capacitance VIN=0V 6 pF
CDQ Input/Output
Capacitance VI/O=0V 8 pF
ABSOLUTE MAXIMUM RATINGS(1) OPERATING RANGE
CAPACITANCE (1) (TA = 25oC, f = 1.0 MHz)
1. Stresses greater than those listed under ABSOLUTE MAXIMUM
RATINGS may cause permanent damage to the device. This is a
stress rating only and functional operation of the device at these
or any other conditions above those indicated in the operational
sections of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
reliability.
1. This parameter is guaranteed and not 100% tested.
SYMBOL PARAMETER RATING UNITS
V
TERM Terminal Voltage with
Respect to GND
-0.5 to
Vcc+0.5 V
T
BIAS Temperature Under Bias -40 to +125 O C
T
STG Storage Temperature -60 to +150 O C
P
TPower Dissipation 1.0 W
I
OUT DC Output Current 20 mA
BS62LV4003
RANGE AMBIENT
TEMPERATURE Vcc
Commercial 0 O C to +70 O C 2.4~3.6V
Industrial -40 O C to +85 O C 2.4~3.6V