Copyright © Murata Manufacturing Co., Ltd. All rights reserved. 2007
SF2134E (R) 3/21/19 Page 1 of 5 www.murata.com
Electrical Characteristics
Electrical Connections
Characteristic Sym Notes Min Typ Max Units
Center Frequency fC897.5 MHz
Insertion Loss, 880 to 915 MHz IL 2.1 3.0 dB
Amplitude Ripple, 880 to 915 MHz 1.0 2.0 dBP-P
Attenuation Referenced to 0 dB
dB
DC to 860 MHz 17 19
925 to 935 MHz 5 12.4
935 to 960 MHz 20 24
980 to 2000 MHz 20 22
VSWR, 880 to 915 MHz 2:1 2.6:1
Source Impedance ZS50
Load Impedance ZL50
Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator 674, YWWS
Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel
Reel Size 13 Inch 3000 Pieces/Reel
Connection Terminals
Input 2
Output 5
Case Ground All others
SM3030-6
• Low-loss UHF SAW Filter
• Surface Mount 3.0 x 3.0 mm Package
Absolute Maximum Ratings
Rating Value Units
Input Power Level 5 dBm
DC Voltage on any Non-ground Terminal 3 V
Operable Temperature Range -45 to +105°C
Specification Temperature Range -20 to +75 °C
Storage Temperature Range in Tape and Reel -40 to +85 °C
Suitable for Lead-free Soldering - Maximum Soldering Profile 260 °C for 30 s
897.50 MHz
SAW Filter
SF2134E
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 and measured with 50 network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd.
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
NOTES:
RoHS Compliance
This component is compliant
with RoHS directive.
This component was always
RoHS compliant from the first
date of manufacture.