DIOTEC ELECTRONICS CORP. Data Sheet No. FRDI-100-1B 18020 Hobart Blvd., Unit B Gardena, CA 90248 U.S.A Tel.: (310) 767-1052 Fax: (310) 767-7958 MECHANICAL SPECIFICATION FEATURES ACTUAL SIZE OF THE FDI PACKAGE PRV Ratings from 50 to 1000 Volts SERIES FDI100 - FDI110 _ Surge overload rating to 50 Amps peak DT + + DT FDI104 A1 A FDI104 Reliable low cost molded plastic construction Ideal for printed circuit board applications C Fast switching for high efficiency D UL RECOGNIZED - FILE #E124962 L1 L MECHANICAL DATA B B1 B2 Case: Molded plastic, U/L Flammability Rating 94V-0 Sym Terminals: Rectangular pins _ Soldering: Per MIL-STD 202 Method 208 guaranteed A A1 B B1 B2 C D L L1 + Polarity: Marked on case Mounting Position: Any Weight: 0.05 Ounces (1.3 Grams) Minimum mm in 0.290 7.4 0.245 6.2 0.41 0.016 0.195 5.0 0.300 7.6 9.3 0.355 0.125 3.2 3.9 0.155 0.060* 1.5* Maximum mm in 8.9 0.310 6.5 0.255 0.51 0.020 0.205 5.2 8.9 0.350 9.3 0.365 3.4 0.135 0.165 4.3 * This dimension is "Typical". MAXIMUM RATINGS & ELECTRICAL CHARACTERISTICS Ratings at 25 C ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive loads, derate current by 20%. PARAMETER (TEST CONDITIONS) RATINGS SYMBOL UNITS Maximum DC Blocking Voltage VRM FDI 100 50 Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 VRRM 50 100 200 400 600 800 1000 Series Number Maximum Peak Recurrent Reverse Voltage o Average Forward Rectified Current @ TA = 40 C Peak Forward Surge Current (8.3mS single half sine wave superimposed on rated load) Maximum Forward Voltage at 1 Amp DC @ TA = 25 C @ TA = 100 oC Maximum Reverse Recovery Time (Note 1) @ TJ = 25 C Maximum Thermal Resistance, Junction to Ambient (Note 2) o FDI 102 200 FDI 104 400 FDI 106 600 FDI 108 800 FDI 110 1000 o VOLTS IO 1 IFSM 50 VFM 1.3 VOLTS IRM 10 1 A mA o Maximum Average DC Reverse Current At Rated DC Blocking Voltage Junction Operating and StorageTemperature Range FDI 101 100 TRR 200 AMPS 300 500 nS RJA 40 C/W TJ, TSTG -55 to +150 C NOTES: (1)TJ=25 C, IF=0.5A, IR=1A, IRR=0.25A (2)Thermal resistance from junction to ambient with bridge mounted on PC Board with 0.5" sq. (13mm sq.) copper pads 3.0101fdi G1