2mmx5mm RECTANGULAR SOLID LAMP WP103HDT Features BRIGHT RED Description LOW POWER CONSUMPTION. The Bright Red source color devices are made with Gallium RELIABLE AND RUGGED. Phosphide Red Light Emitting Diode. EXCELLENT UNIFORMITY OF LIGHT OUTPUT. SUITABLE FOR LEVEL INDICATOR. LONG LIFE - SOLID STATE RELIABILITY. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2571 REV NO: V.1 DATE: APR/16/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101000374-01 Selection Guide Part No. Dice WP103HDT Iv (mcd) @ 10mA Lens Type BRIGHT RED (GaP) RED DIFFUSED Viewing Angle Min. Typ. 2 1/2 0.4 1 110 Note: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device peak Peak Wavelength Bright Red D Dominant Wavelength 1/2 Typ. Units Test Conditions 700 nm IF=20mA Bright Red 660 nm IF=20mA Spectral Line Half-width Bright Red 45 nm IF=20mA C Capacitance Bright Red 40 VF Forward Voltage Bright Red 2.25 IR Reverse Current Bright Red Max. pF VF=0V;f=1MHz 2.5 V IF=20mA 10 uA VR = 5V Absolute Maximum Ratings at TA=25C Parameter Bright Red Units Power dissipation 120 mW DC Forward Current 25 mA Peak Forward Current [1] 130 mA 5 V Reverse Voltage Operating / Storage Temperature -40C To +85C Lead Solder Temperature [2] 260C For 3 Seconds Lead Solder Temperature [3] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2571 REV NO: V.1 DATE: APR/16/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101000374-01 Bright Red WP103HDT Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2571 REV NO: V.1 DATE: APR/16/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101000374-01