SURFACE MOUNT DISPLAY Part Number: ACPSA04-41SEKWA Super Bright Orange Features Description 0.4 inch character height. The Super Bright Orange device is made with AlGaInP (on Low current operation. GaAs substrate) light emitting diode chip. High contrast and light output. Categorized for luminous intensity. Mechanically rugged. Gray face,white segment. Package : 400pcs / reel. Moisture sensitivity level : level 2a. RoHS compliant. Package Dimensions& Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01")unless otherwise noted. 2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. 3.The gap between the reflector and PCB shall not exceed 0.25mm. SPEC NO: DSAG4989 REV NO: V.11A DATE: JAN/08/2015 PAGE: 1 OF 5 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: P.Cheng ERP: 1361000051 Selection Guide Part No. Dice ACPSA04-41SEKWA Iv (ucd) [1] @ 10mA Lens Type Super Bright Orange (AlGaInP) Description Min. Typ. 21000 44000 *5600 *13000 White Diffused Common Anode, Rt. Hand Decimal. Note: 1. Luminous intensity/ luminous Flux: +/-15%. * Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. peak Peak Wavelength Super Bright Orange D [1] Dominant Wavelength 1/2 Max. Units Test Conditions 610 nm IF=20mA Super Bright Orange 601 nm IF=20mA Spectral Line Half-width Super Bright Orange 29 nm IF=20mA C Capacitance Super Bright Orange 15 pF VF=0V;f=1MHz VF [2] Forward Voltage Super Bright Orange 2.1 2.5 V IF=20mA IR Reverse Current Super Bright Orange 10 uA VR=5V Notes: 1. Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. 3. Wavelength value is traceable to the CIE127-2007 compliant national standards. 4. Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25C Parameter Super Bright Orange Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 195 mA 5 V Reverse Voltage Operating / Storage Temperature -40C To +85C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAG4989 REV NO: V.11A DATE: JAN/08/2015 PAGE: 2 OF 5 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: P.Cheng ERP: 1361000051 Super Bright Orange ACPSA04-41SEKWA SPEC NO: DSAG4989 REV NO: V.11A DATE: JAN/08/2015 PAGE: 3 OF 5 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: P.Cheng ERP: 1361000051 ACPSA04-41SEKWA Recommended Soldering Pattern (Units : mm; Tolerance: 0.15) Reel Dimension Tape Specifications (Units : mm) SPEC NO: DSAG4989 REV NO: V.11A DATE: JAN/08/2015 PAGE: 4 OF 5 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: P.Cheng ERP: 1361000051 PACKING & LABEL SPECIFICATIONS ACPSA04-41SEKWA Terms and conditions for the usage of this document 1.The information included in this document reflects representative usage scenarios and is intended for technical reference only. 2.The part number, type, and specifications mentioned in this document are subject to future change and improvement without notice. Before production usage customer should refer to the latest datasheet for the updated specifications. 3.When using the products referenced in this document, please make sure the product is being operated within the environmental and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible for any subsequent issues. 4.The information in this document applies to typical usage in consumer electronics applications. If customer's application has special reliability requirements or have life-threatening liabilities, such as automotive or medical usage, please consult with Kingbright representative for further assistance. 5.The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright. 6.All design applications should refer to Kingbright application notes available at http://www.KingbrightUSA.com/ApplicationNotes SPEC NO: DSAG4989 REV NO: V.11A DATE: JAN/08/2015 PAGE: 5 OF 5 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: P.Cheng ERP: 1361000051 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Kingbright: ACPSA04-41SEKWA