54150/DM54150/DM74150, 54151A/DM54151A/DM74151A Data Selectors/Multiplexers General Description Features These data selectors/multiplexers contain full on-chip decoding to select the desired data source. The 150 selects one-of-sixteen data sources; the 151A selects one-of-eight data sources. The 150 and 151A have a strobe input which must be at a low logic level to enable these devices. A high level at the strobe forces the W output high and the Y output (as applicable) low. The 151A features complementary W and Y outputs, whereas the 150 has an inverted (W) output only. The 151A incorporates address buffers which have symmetrical propagation delay times through the complementary paths. This reduces the possibility of transients occurring at the output(s) due to changes made at the select inputs, even when the 151A outputs are enabled (i.e., strobe low). Y Y Y Y Y Y Y Y 150 selects one-of-sixteen data lines 151A selects one-of-eight data lines Performs parallel-to-serial conversion Permits multiplexing from N lines to one line Also for use as Boolean function generator Typical average propagation delay time, data input to W output 150 11 ns 151A 9 ns Typical power dissipation 150 200 mW 151A 135 mW Alternate Military/Aerospace device (54150, 54151A) is available. Contact a National Semiconductor Sales Office/Distributor for specifications. Connection Diagrams Dual-In-Line Package Dual-In-Line Package TL/F/6546 - 1 Order Number 54150DQMB, 54150FMQB, DM54150J or DM74150N See NS Package Number J24A, N24A or W24C C1995 National Semiconductor Corporation TL/F/6546 TL/F/6546 - 2 Order Number 54151ADMQB, 54151AFMQB, DM54151AJ, DM54151AW or DM74151AN See NS Package Number J16A, N16E or W16A RRD-B30M105/Printed in U. S. A. 54150/DM54150/DM74150, 54151A/DM54151A/DM74151A Data Selectors/Multiplexers June 1989 Absolute Maximum Ratings (Note) Note: The ``Absolute Maximum Ratings'' are those values beyond which the safety of the device cannot be guaranteed. The device should not be operated at these limits. The parametric values defined in the ``Electrical Characteristics'' table are not guaranteed at the absolute maximum ratings. The ``Recommended Operating Conditions'' table will define the conditions for actual device operation. If Military/Aerospace specified devices are required, please contact the National Semiconductor Sales Office/Distributors for availability and specifications. Supply Voltage 7V Input Voltage 5.5V Operating Free Air Temperature Range b 55 C to a 125 C DM54 and 54 DM74 0 C to a 70 C Storage Temperature Range b 65 C to a 150 C Recommended Operating Conditions Symbol DM54150 Parameter VCC Supply Voltage VIH High Level Input Voltage VIL Low Level Input Voltage IOH High Level Output Current IOL Low Level Output Current TA Free Air Operating Temperature DM74150 Units Min Nom Max Min Nom Max 4.5 5 5.5 4.75 5 5.25 2 2 V 0.8 0.8 V b 0.8 b 0.8 mA 16 b 55 V 125 0 16 mA 70 C Max Units b 1.5 V '150 Electrical Characteristics over recommended operating free air temperature range (unless otherwise noted) Symbol VI Parameter Conditions Min Input Clamp Voltage VCC e Min, II e b12 mA VOH High Level Output Voltage VCC e Min, IOH e Max VIL e Max, VIH e Min VOL Low Level Output Voltage VCC e Min, IOL e Max VIH e Min, VIL e Max II Input Current @ Max Input Voltage VCC e Max, VI e 5.5V IIH High Level Input Current IIL IOS ICC Typ (Note 1) 2.4 V 0.4 V 1 mA VCC e Max, VI e 2.4V 40 mA Low Level Input Current VCC e Max, VI e 0.4V b 1.6 mA Short Circuit Output Current VCC e Max (Note 2) Supply Current VCC e Max, (Note 3) DM54 b 20 b 55 DM74 b 18 b 55 Note 1: All typicals are at VCC e 5V, TA e 25 C. Note 2: Not more than one output should be shorted at a time. Note 3: ICC is measured with the strobe and data select inputs at 4.5V, all other inputs and outputs open. 2 40 68 mA mA '150 Switching Characteristics at VCC e 5V and TA e 25 C (See Section 1 for Test Waveforms and Output Load) Symbol Parameter RL e 400X, CL e 15 pF From (Input) To (Output) Min Units Max tPLH Propagation Delay Time Low to High Level Output Select to W 35 ns tPHL Propagation Delay Time High to Low Level Output Select to W 33 ns tPLH Propagation Delay Time Low to High Level Output Strobe to W 24 ns tPHL Propagation Delay Time High to Low Level Output Strobe to W 30 ns tPLH Propagation Delay Time Low to High Level Output E0-E15 to W 20 ns tPHL Propagation Delay Time High to Low Level Output E0-E15 to W 14 ns Recommended Operating Conditions Symbol DM54151A Parameter VCC Supply Voltage VIH High Level Input Voltage VIL Low Level Input Voltage IOH High Level Output Current IOL Low Level Output Current TA Free Air Operating Temperature DM74151A Units Min Nom Max Min Nom Max 4.5 5 5.5 4.75 5 5.25 2 2 0.8 0.8 V b 0.8 mA 16 mA 70 C 125 3 V b 0.8 16 b 55 V 0 '151A Electrical Characteristics over recommended operating free air temperature range (unless otherwise noted) Symbol Parameter Conditions Min VI Input Clamp Voltage VCC e Min, II e b12 mA VOH High Level Output Voltage VCC e Min, IOH e Max VIL e Max, VIH e Min VOL Low Level Output Voltage VCC e Min, IOL e Max VIH e Min, VIL e Max II Input Current @ Max Input Voltage VCC e Max, VI e 5.5V IIH High Level Input Current IIL IOS ICC Typ (Note 1) Max Units b 1.5 V 2.4 V 0.4 V 1 mA VCC e Max, VI e 2.4V 40 mA Low Level Input Current VCC e Max, VI e 0.4V b 1.6 mA Short Circuit Output Current VCC e Max (Note 2) Supply Current VCC e Max, (Note 3) DM54 b 20 b 55 DM74 b 18 b 55 27 48 mA mA Note 1: All typicals are at VCC e 5V, TA e 25 C. Note 2: Not more than one output should be shorted at a time. Note 3: ICC is measured with the strobe and data select inputs at 4.5V, all other inputs and outputs open. '151A Switching Characteristics at VCC e 5V and TA e 25 C (See Section 1 for Test Waveforms and Output Load) Symbol Parameter From (Input) To (Output) RL e 400X, CL e 15 pF Min Units Max tPLH Propagation Delay Time Low to High Level Output Select (4 Levels) to Y 38 ns tPHL Propagation Delay Time High to Low Level Output Select (4 Levels) to Y 30 ns tPLH Propagation Delay Time Low to High Level Output Select (3 Levels) to W 26 ns tPHL Propagation Delay Time High to Low Level Output Select (3 Levels) to W 30 ns tPLH Propagation Delay Time Low to High Level Output Strobe to Y 33 ns tPHL Propagation Delay Time High to Low Level Output Strobe to Y 30 ns tPLH Propagation Delay Time Low to High Level Output Strobe to W 21 ns tPHL Propagation Delay Time High to Low Level Output Strobe to W 25 ns tPLH Propagation Delay Time Low to High Level Output D0-D7 to Y 24 ns tPHL Propagation Delay Time High to Low Level Output D0-D7 to Y 24 ns tPLH Propagation Delay Time Low to High Level Output D0-D7 to W 14 ns tPHL Propagation Delay Time High to Low Level Output D0-D7 to W 14 ns 4 Logic Diagrams 150 TL/F/6546 - 3 5 Logic Diagrams 151A Address Buffers for 54151A/74151A TL/F/6546 - 5 TL/F/6546 - 4 See Address Buffers Below Function Tables 54150/74150 54151A/75151A Inputs Inputs Select D C B A X L L L L L L L L H H H H H H H H X L L L L H H H H L L L L H H H H X L L H H L L H H L L H H L L H H X L H L H L H L H L H L H L H L H Strobe S H L L L L L L L L L L L L L L L L Outputs W Select H E0 E1 E2 E3 E4 E5 E6 E7 E8 E9 E10 E11 E12 E13 E14 E15 C B A X L L L L H H H H X L L H H L L H H X L H L H L H L H Outputs Strobe S Y W H L L L L L L L L L D0 D1 D2 D3 D4 D5 D6 D7 H D0 D1 D2 D3 D4 D5 D6 D7 H e High Level, L e Low Level, X e Don't Care D0, D1 . . . D7 e the level of the respective D input H e High Level, L e Low Level, X e Don't Care E0, E1 . . . E15 e the complement of the level of the respective E input 6 Physical Dimensions inches (millimeters) 16-Lead Ceramic Dual-In-Line Package (J) Order Number 54151ADMQB or DM54151AJ NS Package Number J16A 24-Lead Ceramic Dual-In-Line Package (J) Order Number 54150DMQB or DM54150J NS Package Number J24A 7 Physical Dimensions inches (millimeters) (Continued) 16-Lead Molded Dual-In-Line Package (N) Order Number DM74151AN NS Package Number N16E 24-Lead Molded Dual-In-Line Package (N) Order Number DM74150N NS Package Number N24A 8 Physical Dimensions inches (millimeters) (Continued) 16-Lead Ceramic Flat Package (W) Order Number 54151AFMQB or DM54151AW NS Package Number W16A 9 54150/DM54150/DM74150, 54151A/DM54151A/DM74151A Data Selectors/Multiplexers Physical Dimensions inches (millimeters) (Continued) 24-Lead Ceramic Flat Package (W) Order Number 54150FMQB NS Package Number W24C LIFE SUPPORT POLICY NATIONAL'S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF NATIONAL SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, and whose failure to perform, when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user. National Semiconductor Corporation 1111 West Bardin Road Arlington, TX 76017 Tel: 1(800) 272-9959 Fax: 1(800) 737-7018 2. A critical component is any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. National Semiconductor Europe Fax: (a49) 0-180-530 85 86 Email: cnjwge @ tevm2.nsc.com Deutsch Tel: (a49) 0-180-530 85 85 English Tel: (a49) 0-180-532 78 32 Fran3ais Tel: (a49) 0-180-532 93 58 Italiano Tel: (a49) 0-180-534 16 80 National Semiconductor Hong Kong Ltd. 13th Floor, Straight Block, Ocean Centre, 5 Canton Rd. Tsimshatsui, Kowloon Hong Kong Tel: (852) 2737-1600 Fax: (852) 2736-9960 National Semiconductor Japan Ltd. Tel: 81-043-299-2309 Fax: 81-043-299-2408 National does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and National reserves the right at any time without notice to change said circuitry and specifications.