Product Specifications 3MTM Red Buffer Pad 5100 1.0 Product Description This product is a floor maintenance buffing pad. The pad is made of polyester fiber in an open textured non-woven construction. Cleaning and polishing abrasive particles are dispersed throughout the nonwoven construction and bonded with a durable adhesive. The pad is nominally one inch thick and is made in various sizes. 2.0 Intended Use The pad is used for spray cleaning or dry buffing under a rotary floor machine (175-600 rpm). It is also used for light scrubbing under an automatic scrubber. 3.0 Standard Sizes Circular discs and other shapes are available in a variety of common sizes. 4.0 Color Red 5.0 Requirements: General Requirements: This product shall be made of polyester fibers and synthetic adhesives and shall not be significantly affected by water, detergents and cleaners normally used for floor maintenance. The abrasive cleaning particles shall be natural abrasives. The product shall be reversible and nominally one inch thick. Detailed Requirements Typical Properties: Property O.D. Dimension Value Designated size + 1/16 inch Test Method SB 61 Thickness 1 inch nominal SB 66 Weight (4 in. x 6 in.) 21.2 g Fiber type Polyester mixture of sizes Average tensile strength 68 lbs./2 in. SB 6.4 Alkali Resistance (Tensile Retention) 99% SB 1.6.3 Wear (weight loss) 30% SB 2.0 Recycle content of packaging Not less than 35% post-consumer recycled material Page 2 6.0 7.0 Packaging and Marking Packaging: 5 pads per case Marking: Each carton shall be labeled to identify the contents by product name, size and manufacturer. Each pad shall be printed with manufacturer's name. Pad Use and Cleaning Directions for Use: Dust mop floors before and after spray cleaning or buffing. If floors are heavily soiled, damp mop prior to spray cleaning or buffing. Dust mop prior to scrubbing with automatic scrubber. Pad Cleaning: Pads may be hosed out using a pressure spray nozzle to remove soil. Pads may be soaked in detergent or diluted stripping solution to dissolve caked-on soil or finish prior to cleaning. Important Notice: This flyer is intended to be an introductory summary. The information provided is based upon typical conditions and is believed to be reliable; however, due to the wide variety of intervening factors, 3M does not warrant that the results will necessarily be obtained. All details concerning product specifications and terms of sale are available from 3M. Building and Commercial Services Division St. Paul, MN 55144-1000 1-800-852-9722 www.3M.com/commcare 3M is trademark of 3M. (c) 3M 2007.