PRODUCT DATASHEET
Mechanical
SynJet Cooling Solution shown with Configurable heat si n k
SynJet Wire Harness Connector Pi n o u t
Part Numbers
NX200100
SynJet, ZFlow 90, Level Select, 5V, Black
Configurable to discret e perf ormance settings
NX200101
SynJet, ZFlow 90, PWM, 5V, Black
Use with PWM input to control performance setti ng
SynJet, ZFlow 90, Level Select, 12V, Black
Configurable to discret e perf ormance settings
NX200103
SynJet, ZFlow 90, PWM, 12V, Black
Use with PWM input to control performance setti ng
NX300113
Heatsink, 90W, Industrial Low Bay Cooler, Configurable, Molex Heleion,
Philips Twistable, Black, Al insert Contact sales for other heatsink options
NX300114
Heatsink, 90W, Industrial Low Bay Cooler, Philips SLM, Vossloh-Schwabe,
Black, Al insert Contact sal es for other heatsink options
NX300115 Heatsi nk, 90W, Industrial Low Bay Cooler, Osram PrevaLed, Black, Al insert Contact sales for other heatsink options
NX300116 Heatsi nk, 90W, Industrial Low Bay Cooler, BridgeLux RS, Blac k, A l in sert Cont act sales for other heatsink options
NX300117 Heatsi nk, 90W, Industrial Low Bay Cooler, Zhaga B3, Tridonic, Al, Black Contact sales for other heatsink options
WALLS-C4150-001 Wire Harness, 4-Wire, 150 mm Length Contac t s al es for other wire harness opti ons
WALLS-C4600-001 Wire Harness, 4-Wire, 600 mm Length Contact sales for other wire harness options
5 V or 12 V depending on model
3 Purple CTRL2
Input for Level Select model
Status signal for PWM model
4 Blue CTRL1
Input for Level Select model
PWM input for PWM model
All dimensions are nominal and in mm unless otherwise stated. See product drawings f or more detail.
Nuventix reserves the right to make changes to the products or information cont ai ned herein without notic e. No
liability is assumed as a result of their use or applications. For addit ional information, please contact Nuventix directl y.
IMPOR TAN T: Syn Jets should be compl etely wired to the power supply before the power supply is energized. The power supply s houl d be
turned off before the SynJet Cooler is disconnected. SynJet Coolers are not designed for “hot swap” or “hot plug” applications.