US2A
THRU
US2M
Rectifier
50 t o 1000 Volts
Features
• Glass Passivated Chip
• Super Fast Switching For High Efficiency
• Low Forward Voltage Drop And High Current Capability
• Low Reverse Leakage Current
• Lead Free Finish/Rohs Compliant (Note1) ("P"Suffix designates
• Operating Temperature: -50°C to +150°C
• Storage Temperature: -50°C to +150°C
• Maximum Thermal Resistance; 20 °C/W Junction To Lead
US2A US2A 50V 35V 50V
US2B US2B 100V 70V 100V
US2C US2C 150V 105V 150V
US2D US2D 200V 140V 200V
US2G US2G 400V 280V 400V
US2J US2J 600V 420V 600V
US2K US2K 800V 560V 800V
Electrical Characteristics @ 25°C Unless Otherwise Specified
Average Forward
Current
IF(AV) 2.0A TL = 110°C
5uA
Maximum DC Reverse
Current At Rated DC
Blocking Voltage
*Pulse test: Pulse width 300 µsec, Duty cycle 1%
Maximum
Instantaneous
Forward Voltage
US2A-2D
US2G
US2J-2M
VF 1.0V
1.4V
1.7V
IFM =2.0A;
TJ = 25°C
www.mccsemi.com
Peak Forward Surge
Current
IFSM 50A 8.3ms, half sine
Maximum Ratings
IRTJ = 25°C
TJ = 125°C
350uA
Typical Junction
Capacitance
CJ28pF Measured at
1.0MHz, VR=4.0V
Maximum Reverse
Recovery Time Trr IF=0.5A, IR=1.0A,
Irr=0.25A
US2A-2G 50ns
US2J-2M 75ns
omponents
21201 Itasca Street Chatsworth
!"#
$% !"#
2 Amp Ultra Fast
Compliant. See ordering information)
Note: 1. High Temperature Solder Exemptions Applied, see EU Directive Annex 7.
Revision: D 2013/01/01
1 of 4
MCC
Catalog
Number
Device
Marking
Maximum
Recurrent
Peak Reverse
Voltage
Maximum
RMS
Voltage
Maximum
DC
Blocking
Voltage
US2M US2M 1000V 700V 1000V
• Epoxy meets UL 94 V-0 flammability rating
• Moisture Sensitivity Level 1
MCC TM
Micro Commercial Components
0.070”
0.090"
0.085”
SUGGESTED SOLDER
PAD LAYOUT
H
J
E
G
A
B
D
C
DO-214AA
(SMB) (Lead Frame)
DIMENSIONS
INCHES MM
DIM MIN MAX MIN MAX NOTE
A .075 .095 1.91 2.41
B .077 .083 1.96 2.10
C .002 .008 .05 .20
D ---- - .02 ----- .51
E .030 .060 .76 1.52
G .200 .220 5.08 5.59
H .160 .187 4.06 4.75
J .130 .155 3.30 3.94
0.070”
0.090"
0.085”
SUGGESTED SOLDER
PAD LAYOUT
H
J
E
G
A
B
D
C
DO-214AA
(SMB) (Lead Frame)
DIMENSIONS
INCHES MM
DIM MIN MAX MIN MAX NOTE
A .075 .095 1.91 2.41
B .077 .083 1.96 2.10
C .002 .008 .05 .20
D ---- - .02 ----- .51
E .030 .060 .76 1.52
G .200 .220 5.08 5.59
H .160 .187 4.06 4.75
J .130 .155 3.30 3.94
• Halogen free available upon request by adding suffix "-HF"
US2A thru US2M
Average Forward Rectified Current - Amperes versus
Lead Temperature -°C
Figure 2
Forward Derating Curve
015025 50 75 100
0
.2
.4
.6
.8
1.0
1.2
1.4
Single Phase, Half Wave
60Hz Resistive or Inductive Load
Amps
°C
125
1.6
1.8
2.0
2.2
2.4
Instantaneous Forward Current - Amperes versus
Instantaneous Forward Voltage - Volts
Figure 1
Typical Forward Characteristics
4
6
20
10
Amps
.6 .8 1.0 1.2 1.4 1.6
.01
.02
.04
.06
.1
.2
.4
.6
1
2
Volts
Figure 3
Junction Capacitance
.1 .2 1.4 2 10 20 404 100 200
1
2
6
10
20
100
Junction Capacitance - pF versus
Reverse Voltage - Volts
pF
Volts
60
40
4
400 1000
www.mccsemi.com
TJ=25°C
TJ=25°C
US2A-2D
US2G
US2J
US2K
US2M
Revision: D 2013/01/01
2 of 4
MCC
TM
Micro Commercial Components
US2A thru US2M
trr
+0.5A
0
-0.25
-1.0
1cm
Set Time Base for 20/100ns/cm
25Vdc
1Ω
50Ω10Ω
Oscilloscope
Note 1
Pulse
Generator
Note 2
Notes:
1. Rise Time = 7ns max.
Input impedance = 1 megohm, 22pF
2. Rise Time = 10ns max.
Source impedance = 50 ohms
3. Resistors are non-inductive
Figure 5
Reverse Recovery Time Characteristic And Test Circuit Diagram
1 100
4
0
5
10
20
8
Figure 4
Peak Forward Surge Current
Peak Forward Surge Current - Amperes versus
Number Of Cycles At 60Hz - Cycles
Amps
Cycles
2610 20 60 80
40
30
40
50
www.mccsemi.com
Revision: D 2013/01/01
3 of 4
MCC TM
Micro Commercial Components
MCC TM
Micro Commercial Components
www.mccsemi.com
Revision: D 2013/01/01
4 of 4
2
Device Packing
Part Number-TP Tape&Reel: 3Kpcs/Reel
Ordering Information :
***IMPORTANT NOTICE***
Micro Commercial Components Corp. reserves the right to make changes without further notice to any product herein to
make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components
Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it
convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all
risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are
represented on our website, harmless against all damages.
***LIFE SUPPORT***
MCC's products are not authorized for use as critical components in life support devices or systems without the express written
approval of Micro Commercial Components Corporation.
***CUSTOMER AWARENESS***
Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking
strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages
customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on
our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine
parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty
coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global
problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized
distributors.
Note : Adding "-HF" suffix for halogen free, eg. Part Number-TP-HF
