REV. 6/3/05 L #635 [16.13] MAX| "01" PANEL GROUNDING TAB a L.-.425 [10.79] fe +++ SHORTING BAR (SHORT REMOVED ON PLUG INSERTION) CONTACT SLOTS 123'45 "678 \L we [21.59] MAX~ { NE 5 g j 2, 3 \=(_| 5 O; + & 2 3 | 5, 8 o| & c Cc r | 040 [1.02] 050 [1.27] TYP TOL NON-ACCUM 025 [0.64] Zs 100 [2.54] TYP = TOL NON-ACCUM & 4.035 [0.89] (8) y = ++ 250 [6.35] : ~~ 128 [3.25] #125 [3.18] a Ye 9.062 [1.57] (2) #450 el 120 sos +610 [15.49] P.C.B. RECOMMENDED HOLE LAYOUT SEEN FROM COMPONENT SIDE TOLERANCE +.003 [0.08] UNLESS OTHERWISE SPECIFIED DATE REV ECN APPD. BY 1/25/06 A2 7455 JM NOTES: 1. CONNECTOR MATERIALS: HOUSING: THERMOPLASTIC UL94 V-0 CONTACTS/SHIELD: COPPER ALLOY SHIELD PLATING: NICKEL OR TIN CONTACT PLATING: SELECTIVE GOLD IN CONTACT AREA SEE CHART FOR PART NUMBER 2. FOR PRODUCT SPECIFICATIONS SEE PRO22-01. . TOLERANCES COMPLY WITH F.C.C. DIMENSION REQUIREMENTS. 4. THE SUGGESTED PANEL OPENING IS INTENDED TO GIVE USER THE ABILITY TO HAVE REASONABLE JACK/PANEL CLEARANCES, YET MAINTAIN GROUNDING CAPABILITY. THESE VARIABLES CAN BE ADJUSTED IN EITHER DIRECTION BUT MAY CARRY SOME CONSEQUENCES IN THE FORM OF LOWER MATING FORCES OR TIGHTER ASSEMBLY TOLERANCES. tn 50 MICRO-INCHES [1.27um]} SS6488SANF-101-SB00 CONTACT PLATING IN MATING AREA PART NUMBER THIRD ANGLE PROJECTION -4 Bel Stewart Connector 11118 Susquehanna Trail South Glen Rock, PA 17327-9199 (717) 235-7512 Fax: (717) 235-7954 http: //www.stewartconnector.com DO NOT SCALE DRAWING DRAWING IS SUBJECT TO CHANGE WITHOUT NOTICE EIGHT CONTACT, EIGHT POSITION, SHORTING BAR JACK, ALT SIDE SOLDER TAIL LOCATION, TOP PANEL GROUND AT 15 DIMENSIONS: INCHES [METRIC] | THIS DRAWING AND THE SUBJECT MATTER SHOWN THEREON [PRN BY: 75) | DATE 4 /25/06 UNLESS OTHERWISE SPECIFIED ARE CONFIDENTIAL AND THE PROPRIETARY PROPERTY OF TOLERANCES ARE +.005 [0.13] | BEL STEWART CONNECTOR AND SHALL NOT BE REPRODUCED, | APD BY: JM DATE 1-30-06 ANGLES ARE + 1 COPIED, OR USED IN ANY MANNER WITHOUT PRIOR WRITTEN SHEET NO. CONSENT OF BEL STEWART CONNECTOR. THE SUBJECT [DWG NO. REV. 1 OF 1 MATTER MAY BE PATENTED OR A PATENT MAY BE PENDING. C1640163 A2 2 | 1 AutoCAD