Shenzhen Orient Technology Co ., Ltd ORPC-6N137 ORIENT Photocoupler Product Data Sheet Name: ORPC-6N137 Customer:_________________ Date: _________________ SHENZHEN ORIENT TECHNOLOGY CO.,LTD. Block A 3rd Floor No.4 Building,Tian'an Cyber Park,Huangge Rd,LongGang Dist,Shenzhen,GD TEL0755-29681816 FAX0755-29681200 www.orient-opto.com Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 1 A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 1Features (1) 3.3v / 5V supply voltage (2) low power consumption (3) high speed: 15MBd(typical) (4) VCM=1000V, and the lowest common mode inhibition (CMR) is 10 kv/s (5) when - 40 ~ + 85 temperature of ac and dc performance 2Instructions 6N137 is made up of an efficient AlGaAs light-emitting diode and high-speed optical detector. This design provides good ac and dc isolation between the input and output ends of the photoelectric coupler. The output characteristic of the photodetector is a collector open circuit schottky clamp transistor. The total mode transient immunity should reach 10 kv/pa at 3.3 v. The photoelectric coupler operating temperature range: 40 ~ + 85 . 3Application Range * line receiver isolation *A/ D, D/A converted digital signal isolation * eliminate noise from the ground loop * switching power supply * alternative pulse transformers * motor control system * interface of microprocessor system, computer and peripheral equipment 4Functional Diagram Truth table InputLEDEnable Output 1.NC 5.GND 2.Anode 6.Output 3.Cathode 7.VE(Enable) 4.NC 8.Vcc ON H L OFF H H ON L H OFF L H ON NC L OFF NC H 0.1 capacitor F bypass capacitance needs to be connected between A Pin8 and Pin5 Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 2 A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 5Absolute Maximum Ratings (Ta=25)*1 Parameter Input Output *2 Symbol Rated Value Unit Average Forward Input Current IF 20 mA Reverse Input Voltage VR 5 V Power Dissipation PI 40 mV Enable Input Voltage VE VCC+0.5 V Enable Input current IE 5 mA Output Collector Current IO 50 mA Output Collector Voltage VO 7 V Output Collector Power Dissipation PO 85 mW Supply Voltage VCC 7 V Insulation Voltage Viso 5000 Vrms Working Temperature Topr -40 + 85 Storage Temperature Tstg -55 + 125 Soldering Temperature Tsol 260 *1. Room temperature = 25 . Exceeding the maximum absolute rating can permanently damage the device. Working long hours at the maximum absolute rating can affect reliability. *2. soldering time is 10 seconds. Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 3 A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 6Recommended Operating Conditions Parameter Operating Temperature Supply Voltage Symbol Min Max Unit TA -40 85 2.7 3.6 4.5 5.5 VCC V Low Level Input Current IFL 0 250 A High Level Input Current IFH 5 15 mA Low Level Enable Voltage VEL 0 0.8 V High Level Enable Voltage VEH 2 VCC V Output Pull-up Resistor RL 330 4k N -- 5 TTL Loads Fan Out (at RL=1k per channel) Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 4 A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 7Opto-electronic Characteristics Parameter Symbol Condition Min Typ Max Unit VF IF= 10mA -- 1.38 1.7 V VF/ T IF= 10mA -- -1.5 -- mV/ BVR IR = 10A 5 -- -- V -- 1.5 5 mA -- 34 -- pF -- 3.8 10 A -- 5.8 13 mA Input Forward voltage Temperature Coefficient OF Forward Voltage Reverse Voltage VE=2V,VCC=3.3V Input Threshold Current ITH VO=0.6V IOL (sinking) =13mA Input Capacitance CIN f = 1MHz, VF = 0V Detector VE= 0.5V, High Level Supply Current ICCH Low Level Supply Current ICCL High Level Enable Current IEH VCC= 3.3V,VE=2V -- -0.19 -1.6 mA Low Level Enable Current IEL VCC= 3.3V,VE=0.5V -- -0.41 -1.6 mA High Level Enable Voltage VEH 2 -- -- V Low Level Enable Voltage VEL -- 0.8 V High Level Output Current IOH -- 5 100 A -- 0.3 0.6 V VCC=3.3V,IF=0mA VE= 0.5V, VCC= 3.3V,IF=10mA VE=2V, VCC=3.3V VO=3.2V,IF=250A VE=2V, VCC=3.3V Low Level Output Voltage VOL IF=5mA, IOL (sinking) = 13mA Recommended temperature range (TA= -40--+85,2.7VVCC3.6 V),IF= 7.5mA Unless otherwise stated. Typical valuesTA =25,VCC = 3.3 V. Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 5 A0 Shenzhen Orient Technology Parameter Co ., Ltd ORPC-6N137 Symbol Condition Min Typ Max Unit VF IF= 10mA -- 1.38 1.7 V VF/ T IF= 10mA -- -1.5 -- mV/ Reverse Voltage BVR IR = 10A 5 -- -- V Input Threshold Current ITH -- 1.35 5 mA Input Capacitance CIN -- 34 -- pF -- 6.1 10 A -- 8.3 13 mA Input Forward voltage Temperature Coefficient OF Forward Voltage VCC=5.5V,VO=0.6V IOL>13mA f = 1MHz, VF = 0V Detector VE= 0.5V, High Level Supply Current ICCH Low Level Supply Current ICCL High Level Enable Current IEH VCC= 5.5V,VE=2V -- -0.6 -1.6 mA Low Level Enable Current IEL VCC= 5.5V,VE=0.5V -- -0.9 -1.6 mA High Level Enable Voltage VEH 2 -- -- V Low Level Enable Voltage VEL -- 0.8 V High Level Output Current IOH -- 0.9 100 A -- 0.3 0.6 V VCC=5.5V,IF=0mA VE= 0.5V, VCC= 5.5V,IF=10mA VE=2V, VCC=5.5V VO=5.5V,IF=250A VE=2V, VCC=5.5V Low Level Output Voltage VOL IF=5mA, IOL (sinking) = 13mA Recommended temperature range(TA= -40--+85,4.5VVCC5.5V),IF= 7.5mA Unless otherwise stated. Typical values TA =25,VCC = 5.0V. Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 6 A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 8Switching Characteristics Parameter Propagation delay time to output High level Propagation delay time to output Low level Pulse Width Distortion Output Rise Time (10 to 90%) Output Fall Time (90 to 10%) Propagation Delay Time of Enable from VEH to VEL Propagation Delay Time of Enable from VEL to VEH Symbol Condition Min Typ Max Unit tPLH 25 48 90 ns tPHL 25 35 75 ns -- 13 -- ns tr -- 21 -- ns tf -- 6.6 -- ns -- 27 -- ns -- 9 -- ns RL=350 |tPLH-tPHL| tELH tEHL CL=15pF RL=350 CL=15pF VEL=0V VEH=3V Recommended temperature range (TA= -40--+85,2.7VVCC3.6 V),IF= 7.5mA Unless otherwise stated. Typical values TA =25,VCC = 3.3 V Parameter Propagation delay time to output High level Propagation delay time to output Low level Pulse Width Distortion Symbol tPLH tPHL TA=25 RL=350 CL=15pF |tPLH-tPHL| Output Rise Time (10 to 90%) tr Output Fall Time (90 to 10%) tf Propagation Delay Time of Condition tELH Copyright(c) 2018 Orient Tech Corporation.All rights Reserved RL=350 CL=15pF RL=350 7 Min Typ Max Unit 25 40 75 -- -- 100 25 32 75 -- -- 100 -- 8 -- ns -- 22 -- ns -- 6.9 -- ns -- 28 -- ns ns ns A0 Shenzhen Orient Technology Enable from VEH to VEL Co ., Ltd ORPC-6N137 CL=15pF Propagation Delay Time of VEL=0V tEHL Enable from VEL to VEH VEH=3V -- 12 -- ns Recommended temperature range (TA= -40--+85,4.5VVCC5.5V),IF= 7.5mA Unless otherwise stated. Typical values TA =25,VCC = 5.0 V Parameter Symbol Condition VCC=3.3V,VCM=1000V,RL=350 Logic High Common Mode Transient Immunity IF=0mA,TA=25 |CMH| VCC=5V,VCM=1000V,RL=350 IF=0mA,TA=25 VCC=3.3V,VCM=1000V,RL=350 Logic Low Common Mode Transient Immunity IF=10mA,TA=25 |CML| VCC=5V,VCM=1000V,RL=350 IF=10mA,TA=25 Parameter Input-Output Insulation Leakage Current Withstand Insulation Test Voltage Symbol Condition 45% RH,t=5s, II-O VISO VI-O = 3kV DC,TA =25 C Min 10 Typ Max 15 -- Unit kV/s 10 15 -- 10 15 -- kV/s 10 15 -- Min Typ Max Unit -- -- 1 A -- -- VRMS -- RH 50%, t =1min,TA=25 5000 Input-Output Resistance RI-O VI-O = 500V DC -- 1012 Input-Output Capacitance CI-O f = 1MHz, TA = 25 C -- 1 p Recommended temperature range (TA=40-85) Unless otherwise stated. Typical values TA =25. Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 8 A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 9Naming Rule NOTE 1year Code '08' means' 2008 ', '09' means' 2009 'and so on. 2) Week Code 01 represents the first week, 02 represents the second week, and so on. (3)ORManufacturer name, representing manufacturer Shenzhen Orient Components Co., Ltd. (4) Type code: representing type 6N137. (5)Anode Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 9 A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 10 Outer Dimension 1OR-6N137 2OR-6N137M 3OR-6N137S 11Recommended Foot Print Patterns (Mount Pad) (unitmm) Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 10 A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 12Taping Dimensions 1OR-6N137-TA 2OR-6N137-TA1 type symbol Size: mm inches bandwidth W 160.30.63 pitch P0 40.10.15 F 7.50.10.295 P2 20.10.079 P1 120.10.472 pitch interval Encapsulation TA/TA1 type amount pcs Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 1000 11 A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 13Temperature Profile Of Soldering 1IR Reflow soldering (JEDEC-STD-020C compliant) Note: one solder backflow is recommended under the conditions described below in the temperature and time profile. Do not weld more than three times. Configuration items conditions Preheat - TSmin 150C - TSmax 200C - Time (min to MaxTS 9030 sec Soldering zone - temperature TL 217C - timetL 60100 sec 260C Peak Temperature 3C / sec max. Ramp-up rate Drop rate 3C / sec max. Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 12 36C / sec A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 2Wave soldering (JEDEC22A111 compliant) One-time welding is recommended under the temperature condition. Temperature 260+0/-5C Time 10 sec Preheat temperature 5 to 140C 30 to 80 sec Preheat time 3Hand soldering by soldering iron Single lead welding is allowed in each process and one-time welding is recommended. Temperature 380+0/-5C Time 3 sec max Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 13 A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 14Switching time test circuit Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 14 A0 Shenzhen Orient Technology Co ., Ltd ORPC-6N137 15Characteristics Curve Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 15 A0 Shenzhen Orient Technology Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 16 Co ., Ltd ORPC-6N137 A0 Shenzhen Orient Technology Copyright(c) 2018 Orient Tech Corporation.All rights Reserved 17 Co ., Ltd ORPC-6N137 A0