4
Table 1. Regulatory Compliance
Feature Test Method Performance
Electrostatic Discharge
(ESD) to the Electrical
Pins
MIL-STD-883C Method 3015.4
JEDEC/EIA JES022-A114-A
Class 2 (2000 Volts)
Electrostatic Discharge
(ESD) to the RJ 45
Connector Receptacle
Variation of IEC 61000-4-2 Typically withstand 15 KV ( Air Discharge), 8 KV
(Contact) without damage when the RJ 45 connector
receptacle is contacted by a Human Body Model probe.
Electromagnetic
Interference (EMI)
FCC Part 15 Class B
CENELEC EN55022 Class B
(CISPR 22A)VCCI Class 1
System margins are dependent on customer board and
chassis design.
Radiated Immunity Variation of IEC 61000-4-3 Typically shows a negligible e ect from a 10 V/m eld
swept from 80 to 1000 MHz applied to the transceiver
without a chassis enclosure.
Component
Recognition
Underwriters Laboratories and Canadian
Standards Association Joint Component
Recognition for Information Technology
Equipment Including Electrical Business
Equipment
UL File # E173874
Grounding
Con guration
DC short between signal and chassis
grounds
- Meets all regulatory requirements as listed above.
- Compliant with system boards using multi-point
grounding scheme
ROHS Compliance Chemical composition analysis Less than 0.1% lead, mercury, hexavalent chromium,
polybrominated biphenyls, and polybrominated
biphenyl ethers by weight of homogeneous material.
Exemption for lead in high melting temperature solder
applied to module connector. Less than 0.01% cadmium
by weight of homogeneous material.
Application Support
Evaluation Kit
To help you in your preliminary transceiver evaluation,
Avago Technologies o ers a 1.25 GBd Gigabit Ethernet
evaluation board. This board will allow testing of the
electrical parameters of transceiver. Please contact your
local Field Sales representative for availability and order-
ing details.
Reference Designs
Reference designs for the SFP transceiver and the HDMP-
1636A physical layer IC are available to assist the equip-
ment designer. Figure 4 depicts a typical application
con guration, while Figure 5 depicts the MSA power
supply lter circuit design. Please contact your local Field
Sales engineer for more information regarding applica-
tion tools.
Regulatory Compliance
See Table 1 for transceiver Regulatory Compliance perfor-
mance. The overall equipment design will determine the
certi cation level. The transceiver performance is o ered
as a gure of merit to assist the designer.
Electrostatic Discharge (ESD)
There are two conditions in which immunity to ESD
damage is important. Table 1 documents our immunity
to both of these conditions. The rst condition is during
handling of the transceiver prior to insertion into the
transceiver port. To protect the transceiver, it is important
to use normal ESD handling precautions. These precau-
tions include using grounded wrist straps, work benches,
and oor mats in ESD controlled areas. The ESD sensitiv-
ity of the ABCU-5700/5710RZ is compatible with typical
industry production environments.
The second condition is static discharges to the exterior
of the host equipment chassis after installation. To the
extent that the RJ45 connector interface is exposed to the
outside of the host equipment chassis, it may be subject
to system-level ESD requirements. The ESD performance
of the ABCU-5700/5710RZ exceeds typical industry stan-
dards.
Immunity
Equipment hosting the ABCU-5700/5710RZ modules will
be subjected to radio-frequency electromagnetic elds
in some environments. The transceivers have excellent
immunity to such elds due to their shielded design.