Datamate Connectors Male Vertical Off-The-Shelf A selection of stocked Datamate Mix-Tek solder tail standard layouts. Choice to suit two PCB thicknesses and two stud lengths. Mates with connectors shown on page 79. DATAMATE Mix-TEK Calculation POWER CONTACTS ONLY A B 4.50 5.55 4.00 A B + 14 B (No. of Power contacts - 1) x 4 C B+9 0.50 C M2 (all threads) Jackscrew with Board Mount 5.60 C B 4.50 4.00 Stud O1.60 x No. of Power Contacts O2.20 x 2 (for Board Mount) Jackscrew 3.00 O1.50 Tail Recommended PC Board Pattern O4.00 HOW TO ORDER M80 - 5000000 XX - XX - XXX - 00 - 000 JACKSCREW Refer to page 77 for stocked sizes. POWER CONTACT PART NO. M1 Jackscrew only M2 With 3.5mm Board Mount stud No. OF POWER CONTACTS 331 3.5mm Tail M3 With 5mm Board Mount stud 02, 04, 06, 08, 10 332 5 mm Tail Calculation SIGNAL AND POWER CONTACTS A B 2.00 2.00 4.50 4.00 A B + 13 B (No. of Power contacts - 1) x 4+ Total no. of Signal contacts +1 C B+8 5.55 3.00 C 0.50 M2 (all threads) Jackscrew with Board Mount 5.60 C B 1.00 2.00 Stud Jackscrew O0.50 O1.50 3.00 O1.60 x No. of Power Contacts O0.65 x Total No. of Signal Contacts O2.20 x 2 (for Board Mount) 2.00 Tail O4.00 4.50 4.00 3.00 Recommended PC Board Pattern HOW TO ORDER M80 - 5T1 XX 05 XX - XX - 331 - 00 - 000 JACKSCREW Refer to page 77 for stocked sizes. NO. OF SIGNAL CONTACTS M1 Jackscrew only No. OF POWER CONTACTS 02, 04, 06, 08, 12 M2 With 3.5mm Board Mount stud 02, 04 All dimensions in mm. www.harwin.com 80