Product Bulletin OTPDR2001-LR 10 Gb/s OC - 192 MSA Transceiver/Transponder Long Reach The OTPDR2001-LR is a mechanically compliant 300 pin MSA, SONET OC-192/GR-1377 transceiver/transponder. The transceiver/ transponder uses a LiNbO3 modulator and a CW laser. The modules are available with 0, 3, or 7 dBm of optical output power. The features of the transceiver/transponder include integrated electrical mux (performs parallel electrical to serial optical signal conversion), and a demux that performs a serial optical to parallel electrical conversion. The transceiver/transponder is available with wavelengths on the ITU grid (200, 100, and 50 GHz spacing), as well as an integrated high sensitivity PIN or APD receiver. The unit is fully compliant to OIF 99.102.8 specifications. The long reach module has one of the smallest standard form factor packages in the industry, (3.5 x 4.5 x 0.53 inches), and has the identical form factor as its short, intermediate and extended reach counterparts. 10.333 Gb/s ethernet or 10.7 Gb/s FEC (forward error correction) transport which can transmit and receive through lengths up to 100 km of single-mode fiber. The Long Reach is designed for the following typical link budgets: Applications Telecommunications: - Long haul networks - Metropolitan area networks - Long reach ethernet High bit-rate data communications 1550 nm TDM 7 dBm with APD 30 dB, 1550 nm DWDM 3 dBm with APD 26 dB, 1550 nm DWDM 0 dBm with APD 23 dB. The electrical interface consists of 16 differential LVDS lines of data at 622.08, 645, or 666.51 Mb/s in both the transmit and receive directions. The optical interface is a 9.95328 Gb/s SONET optical, Key Features Mechanically compliant with the 300 pin multisource agreement (MSA) SONET OC-192 / GR-1377 compliant Link budgets up to 30 dB Integrated 10 Gb/s optical transmitter and receiver with dual rate 16-channel mux/demux Receiver sensitivity PIN -14 dBm optical input power (@BER = 10-12) APD -24 dBm optical input power (@BER = 10-12) No DC power sequencing required Low power dissipation Available in FEC rate and 10 G ethernet versions OTPDR2001-LR | 2 Configuration LsTEMPALM LsTEMPMON TxSKEWSEL0,1 LsPOWMON TxLOCKERR TxDinP/N[15:0] LsBIASALM Laser TEC Control Mux TxPICLKP/N Laser BIAS CW Laser TxREFCLKP/N LsBIASMON LsENABLE LiNbO3 Modulator Modulator Control 10 GBps Modulator PD Bias RxLOPMON Driver TxPCLKP/N PD RxDoutP/N[15:0] DeMux RxPOCLKP/N 10 GBps Serial Optical Output 10 GBps Clock & Data Recovery Limiting Amp 10 GBps Serial Optical Input TIA RxLOCKERR Rx REFCLK Rx REFSEL0 Rx LCKREF Specifications Parameter Symbol Operating case temperature Total power dissipation 3.3 V supply voltage Vdd current drain 5 V supply voltage Vcc current drain -5.2 V supply voltage Vee current drain Tc P Vdd Idd Vcc Icc Vee. Iee Minimum 3.13 V 4.75 V -5.46 V Typical 0 to 65 C 14 W 3.30 V 0.9 A 5.00 V 0.05 A -5.20 V 2.1A Maximum 3.47 V 5.25 V -4.75 V OTPDR2001-LR | 3 Transceivers Pin Out Notes Symbol I/O Type TxDinP/N[15:0] TxPICKLP/N TxREFCLKP/N TxPCLKP/N TxSKEWSEL0 TxSKEWSEL1 RxREFCLKP/N RxDoutP/N[15:0] RxPOCLKP/N RxLCKREF I I I O I I I O O I LVDS LVDS LVPECL LVDS LVTTL LVTTL LVPECL LVDS LVDS LVTTL Description Parallel data input to the transmitter. Parallel input clock to the transmitter. Transmitter reference clock used to generate TxPCLK. Internally AC coupled. Transmit parallel output clock used to drive framer. Adjusts skew of TxPICLK (LSB) Adjusts skew of TxPICLK (MSB) Receiver reference clock used to verify RxPOCLK. Internally AC coupled. Parallel data output from the receiver. Parallel output clock from the receiver. Locks RxPOCLK to RxREFCLK (active low). RxLOCKERR TxLOCKERR LsPOWMON O O O LVTTL LVTTL Analog RxLOPMON RxREFSEL0 O I Analog LVTTL LsBAISMON LsENABLE O I Analog LVTTL LsBIASALM O LVTTL LsTEMPALM O LVTTL Receiver PLL lock detector is logic-low when the receiver PLL circuit is out of lock. Transmitter PLL lock detector is logic-low when the transmitter PLL circuit is out of lock. Laser power monitor voltage is normalized (0.5 V) at the beginning of life relative to the initial optical output power. The 50% drift in output power correlates to a 50% variation on the laser power monitor voltage. Input power monitor voltage is proportional to the optical mean power detected. 3 mV/mA Receiver reference frequency selector when logic low selects 155.52 MHz, when logic high selects 622.08 MHz (SONET rate). Laser bias current voltage is proportional to the laser current. 5 mV/mA When transmitter laser enable is logic-low the laser is enabled. When logic-high, the laser is disabled. Laser degraded alarm; the digital alarm output will shift from logic-high to logic-low state when the laser approaches its end of life condition. Laser temperature. Normal operating is logic-high. Alarm actives (logic-low) when temperature is approximately 2.5 C above or below normal temperature. OTPDR2001-LR | 4 Ordering Information Indicate your requirements by selecting one option from each configuration table. Please print the corresponding codes in the available boxes to form your part number. For more information on this or other products and their availability, please contact your local JDS Uniphase sales representative or JDS Uniphase directly at 215 328-6500, by fax at 215 675-8414, or via e-mail at sales.pa@us.jdsuniphase.com. Visit our Web site at www.jdsuniphase.com. Sample: OTPDR2001-LR-00-62-PIN- SON-LC OTPDR2001- L R Code LR - Code PIN APD Reach Long reach Code 00 03 07 - - - ReceiverType PIN receiver APD receiver Power Level 0 dBm output (TDM or DWDM) 3 dBm output (TDM or DWDM) 7 dBm output (TDM only) Code SON ETH FEC Code SC FC LC Connectors SC FC LC Data Rate Sonet Ethernet Forward Error Correction Code Frequency (GHz) Wavelength (nm) Code Frequency (GHz) Wavelength (nm) 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 191600 191700 191800 191900 192000 192100 192200 192300 192400 192550 192600 192700 192800 192900 193000 193100 193200 193300 193400 193500 193600 193700 193800 193900 1564.68 1563.86 1563.05 1562.23 1561.42 1560.61 1559.79 1558.98 1558.17 1557.36 1556.55 1555.75 1554.94 1554.13 1553.33 1552.52 1551.72 1550.92 1550.12 1549.32 1548.51 1547.72 1546.92 1546.12 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 194000 194100 194200 194300 194400 194500 194600 194700 194800 194900 195000 195100 195200 195300 195400 195500 195600 195700 195800 195900 196000 196100 196200 1545.32 1544.53 1543.73 1542.94 1542.14 1541.35 1540.56 1539.77 1538.98 1538.19 1537.40 1536.61 1535.82 1535.04 1534.25 1533.47 1532.68 1531.90 1531.12 1530.33 1529.55 1528.77 1527.99 Frequencies are accurate values, wavelengths are dependent on the media properties JDS Uniphase Corporation 200 Precision Road Horsham, PA 19044 USA Tel 215 328-6500 Fax 215 675-8414 sales.pa@jdsuniphase.com www.jdsuniphase.com All information contained herein is believed to be accurate and is subject to change without notice. No responsibility is assumed for its use. JDS Uniphase Corporation, its subsidiaries and affiliates, or manufacturer, reserve the right to make changes, without notice, to product design, product components, and product manufacturing methods. Some specific combinations of options may not be available. Please contact JDS Uniphase for more information. (c)JDS Uniphase Corporation. All rights reserved. MKT-DS-0215 Rev.001 03/01 Printed in Canada