E1 16 QB-F14T16-01 R20UT0544XJ0200 Rev 2.00 2012.7.3 E1 14 QB-MINI2 PG-FP5 16 User's Manual This product is adapter for exchanging the connection from 14 pin interface used for E1 emulator to 16 pin interface used for QB-MINI2 and PG-FP5. 1. System Configuration This product is used as following system configuration. 2. Figure The figure of this product is below. 4. Note 78K0 - E1 4/8/16MHz - UART E1 JP2 - 78K0/Kx1+, uPD78F0711, uPD78F0712, uPD78F0714 JP3 : R20UT0544XJ0200 Rev.2.00 2012.7.3 Page 1 of 2 R20UT0544XJ0200 Rev 2.00 2012.7.3 16 pin Exchange Adapter for E1 Emulator QB-F14T16-01 User's Manual This product can be exchanged with a new product only when it has an initial failure. Note regarding to use E1 emulator for 78K0 micro as following. - E1 emulator can provide 4/8/16 MHz clock, but not provide other clock. - If the programming UART is connected to not only E1 emulator but also another device on the target system, open the JP2 short pad when debugging. In case of programming, short the JP2 (default setting). - If you use 78K0/Kx1+, uPD78F0711, uPD78F0712, uPD78F0714, open the JP3 short pad when programming. In case of debugging, short the JP3 (default setting). ). Splitting this wiring leaves open the relevant circuit ( Pattern on the board: To reconnect the circuit, short the circuit by soldering ( R20UT0544XJ0200 Rev.2.00 2012.7.3 ). Page 1 of 2 14pin side (E1) 2 10 5 8 7 13 1 11 3 16pin side (Target) JP2 JP1 1 2 3 4 5 6 7 8 9 10 11 9 12 4 6 14 JP3 Circuit diagram 12 13 14 15 16 R20UT0554XJ0200 Rev.2.00 Page 2 of 2