Ferrule Data Chart for Bel-Stewart Ferrule Hand Tool Cable Dia. .005 .125 .135 .145 .155 .165 .175 .185 .195 .205 .215 .225 .235 .245 .255 .255 .265 Ferrule Hand Tool Part Number Part Number Ferrule Crimp Inserts Ram Stationary Insert p/n Insert p/n 2912515-01 2912516-01 2912520-01 2912521-01 2912525-01 2912526-01 2912530-01 2912531-01 2912535-01 2912536-01 2912535-01 2912582-01 2912536-01 2912583-01 F-210-205 F-235-205-L F-270-205 F-270-205 F-300-275 2940211-01 Locator Plate Complete Ass'y. Part Number Part Number 2912517-01 2912518-01 2912519-01 2912522-01 2912523-01 2912524-01 2912527-01 2912528-01 2912529-01 2912532-01 2912533-01 2912534-01 2912537-01 2912538-01 2912540-01* 2912584-01 2912501-01 2912502-01 2912503-01 2912504-01 2912505-01 2912506-01 2912507-01 2912508-01 2912509-01 2912510-01 2912511-01 2912512-01 2912513-01 2912514-01 2912539-01 2912585-01 NOTE: 1. If cable diameter falls in between sizes shown, round up to next .005 increment. 2. ( * ) at part #2912540-01 = 4mm hex nut; no Locator Plate needed. Bel-Stewart Connector Ferrule Hand Tool Instructions P/N 2940211-01 Manual #290005 - Rev. A2 Bel-Stewart Connector 11118 Susquehanna Trail South Glen Rock, PA 17327-9199 (717) 235-7512 ASSEMBLY INSTRUCTIONS Stationary Crimp Insert 29125xx-01 (See chart on back page) Locator Plate 29125xx-01 (See chart on back page) Ram Insert 29125xx-01 (See chart on back page) A B 1 2 3 This tool incorporates an eccentric axle and an adjustment wheel to adjust and recalibrate to ensure correct crimp performance. Should adjustment be necessary, the following procedure should be followed: 4 1. 2. 3. 4. 5 Position "Stationary Crimp Insert" as shown. Install "Insert" with screw. Use 2.5mm Allen wrench. Position "Ram Crimp Insert" as shown. Place "Insert" on hand tool label side & position "Locator Plate" on opposite side. 5. Install "Insert" & "Plate" with screw. Use 2.5mm Allen wrench. 1. Loosen and remove the Combination Head screw (A). 2. Using a screw driver, turn the numbered adjustment wheel to the next higher/lower number (B). 3. Re-install the Combination Head Screw and tighten.