.125 2912517-01 2912501-01
.135 2912518-01 2912502-01
.145 2912519-01 2912503-01
.155 2912522-01 2912504-01
.165 2912523-01 2912505-01
.175 2912524-01 2912506-01
.185 2912527-01 2912507-01
.195 2912528-01 2912508-01
.205 2912529-01 2912509-01
.215 2912532-01 2912510-01
.225 2912533-01 2912511-01
.235 2912534-01 2912512-01
.245 2912537-01 2912513-01
.255 2912538-01 2912514-01
.255 F-270-205 2912535-01 2912536-01 2912540-01* 2912539-01
.265 F-300-275 2912582-01 2912583-01 2912584-01 2912585-01
Cable
Di a.
±.005
F errule
P art Num ber Hand Tool
Part Number
F-210-205
F-235-205-L
F-270-205
2940211-01
2912535-01 2912536-01
2912520-01 2912521-01
2912525-01 2912526-01
Loc at or Pl at e
Part Number
Ferrule Data Chart for Bel-Stewart Ferrule Hand Tool
Complete Ass'y.
P art Number
2912530-01 2912531-01
Ferrule Crim p Ins ert s
Stationary
In se r t p /n Ram
Inse rt p/n
2912515-01 2912516-01
N
OTE:
1. If cable diameter falls in between sizes
shown, round up to next .005 increment.
2. ( * ) at part #2912540-01 = 4mm hex nut; no
Locator Plate needed. Bel-Stewart Connector
Ferrule Hand Tool Instructions
P/N 2940211-01
Manual #290005 – Rev. A2
Bel-Stewart Connector
11118 Susquehanna Trail South
Glen Rock, PA 17327-9199
(717) 235-7512
Stationary
Crimp Insert
29125xx-01
(See chart on
back page)
Locator Plate
29125xx-01
(See chart on
back page)
Ram
Insert
29125xx-01
(See chart on
back page)
A
ASSEMBLY INSTRUCTIONS
B
1 32
This tool incorporates an eccentric axle
and an adjustment wheel to adjust and re-
calibrate to ensure correct crimp
performance.
Should adjustment be necessary, the
following procedure should be followed:
1. Loosen and remove the
Combination Head screw (A).
2. Using a screw driver, turn the
numbered adjustment wheel to
the next higher/lower number (B).
3. Re-install the Combination Head
Screw and tighten.
4 5
1. Position “Stationary Crimp Insert” as shown.
2. Install “Insert” with screw. Use 2.5mm Allen wrench.
3. Position “Ram Crimp Insert” as shown.
4. Place “Insert” on hand tool label side & position “Locator
Plate” on opposite side.
5. Install “Insert” & “Plate” with screw. Use 2.5mm Allen wrench.