040III HIGH DENSITY CONNECTOR
72POS/86POS/94POS/108POS/122POS/125POS
108-5673
Rev C2
27JUN06
タイコ エレクトロニクス アンプ株式会社 (〒213-8535 川崎市高津区久本 3-5-8)
1 of 10
Tyco Electronics AMP K.K. (3-5-8 Hisamoto Takatsu-ku Kawasaki, 213-8535)
この文書の改版の確認は本社、支店へお問い合わせください。 This document is subject to change. Call local AMP for the latest revision.
© Copyright 2002 by Tyco Electronics AMP K.K. All rights reserved.
* : 商標 Trademark
1. Scope:
1.1 Contents
This specification covers the requirements for product performance, test methods and quality
assurance provisions of 040Ⅲ HIGH DENSITY CONNECTOR
72pos/86Pos/94Pos/108Pos/122Pos/125Pos for Wire-to-Board Termination.
Applicable product description and part numbers are as shown in Appendix 1.
2. Applicable Documents:
The following documents form a part of this specification to the extent specified herein. In the event of
conflict between the requirements of this specification and the product drawing, the product drawing
shall take precedence. In the event of conflict between the requirements of this specification and the
referenced documents, this specification shall take precedence.
2.1 AMP Specifications:
A. 109-5000 :Test Specification, General Requirements for Test Methods
B. 114-5217 : Crimping 040 Ⅲ Series Receptacle Contact
C. 501-5487 : Qualification Test Report
2.2 Commercial Standards and Specifications.
A. JASO D605 : Multi-pole Connector for Automobiles
B. JASO D7101 : Test Methods for Plastic Molded Parts
C. JIS C3406 : Low Voltage Wires and Cables for Automobiles
D. JIS D0203 : Method of Moisture, Rain and Spray Test for Automobile Parts
E. JIS D0204 : Method of High and Low Temperature Test for Automobile Parts
F. JIS D1601 : Vibration Testing Method for Automobile Parts
G. JIS R5210 : Portland Cement
H. MIL-STD-202 : Testing Method 208 : Method of Soldering