Aethercomm’s celLNA2 was designed for use in
world wide cell sites. Its frequency range has
been optimized for use from 806 to 956 MHz. It
can be used in the following systems:
AMPS, NAMPS, 800 MHz CDMA, TACS, NMT, TDMA
& GSM.
CelLNA2 is a low cost, low noise amplifier which
offers outstanding linearity, high gain, good gain
stability over temperature, low noise and excellent
input and output return loss. This amplifier runs from
5 to 15 Vdc. Size is 2.5” by 3.5” and can be resized
for special packaging requirements.
This is an example of an Aethercomm standard
product. We can design and manufacture high
performance amplifiers for any application from
DC to 50 GHz.
If you need a low cost, low noise, ultralinear, high gain amplifier, check out Aethercomm’s celLNA series and pcsLNA series
of amplifiers. We offer sub 1 dB noise figures with OIP3’s approaching 50 dBm. We can temperature compensate your
amplifier for less than 0.5 dB gain variation from -40 to +85C.
Aethercomm is expert in the design, development and manufacturing of RF, microwave and millimeterwave amplifiers,
transmitters, receivers and other communication systems components utilized by commercial wireless, military and
satellite communications customers.
Aethercomm, Inc. 2910 Norman Strasse Rd., Ste. 105 |San Marcos, CA 92069 |Tel 760.598.4340
Fax 760.598.4342 |Internet: www.aethercomm.com |email: sales@aethercomm.com
celLNA2
•+47 dBm OIP3
•1.1 dB noise figure
•Low cost
•>20 dB I/O return loss
Low Noise Amplifier
Worst Case Performance from 806-956 MHz
Parameter -35C +25C +85C
Noise Figure (dB)0.91.11.3
Input Return Loss (dB)-20.0-25.0-23.0
Output Return Loss (dB)-29.0-33.0-31.0
OIP3 (dBm)48.047.046.5
IIP3 (dBm)9.610.911.1
P1dB (dBm)28.027.026.2
PSat (dBm)30.730.029.2
Gain Stability over Temperature
FrequencyTyp GainTyp GainTyp GainW/C Gain
(MHz)-35C (dB)+25C (dB)+85C (dB)Change (dB)
80638.437.636.80.8
82438.537.736.90.8
84938.537.736.90.8
95636.936.135.40.8
Typical gain slope from 806 to 956 MHz <0.01 dB/MHz.
