PI6C490097 PLL Clock Multiplier Features Description IISupport XTAL or Clock input at 25MHz The PI6C490097 is a low jitter clock generator supporting either XTAL or reference input. Two of its buffered outputs can support wide operating voltage from 1.8V to 3.3V. It is a cost effective way to generate multiple outputs for all kinds of applications that need 25MHz with different power supplies and a 32kHz clock signal. IIThree buffered outputs support VDD operation IIOne 32.768 kHz output IIVery low phase jitter(RMS), 25MHz : < 0.5ps IIVery low additive jitter: <250fs (typ) II3.3V supply voltage for Core II1.8V ~ 3.3V supply voltage for two outputs IIPackaging: 16-pin TSSOP IICommercial & Industrial Temperature support Applications IINetworking Systems IIFemtocell BTS IIPeripheral Block Diagram Pin Configuration (16-Pin TSSOP) VDD VDDO X2 Crystal Oscillator 16 X2 VDD 2 15 GND GND 3 14 VDD 4 13 CLK3 VDD CLK1 VDDO32 5 12 CLK2 CLK2 CLK32 6 11 VDDO GND 7 10 CLK3 OE# 8 9 GND CLK1 GND 12-0164 1 CLK32 PLL X1/CLKIN X1/ICLKIN VDDO32 16-pin (173 mil) TSSOP OE# 1 www.pericom.com PI6C490097 RevA 2/06/2012 PI6C490097 PLL Clock Multiplier Pin number Pin Name Type Description 1 X1/CLKIN Input Crystal connection or clock input 2, 4, 14 VDD Power Supply voltage 3.3V 5 VDDO32 Power Supply voltage for CLK32 6 CLK32 Output 32.768 kHz output 7, 9, 15 GND Power Connect to Ground 8 OE# Input Global output enable when low. Internal pull-down resistor. 10 CLK3 Output Clock Output 3 11 VDDO Power Supply voltage from 1.8V to 3.3V for CLK2 and CLK3 12 CLK2 Output Clock Output 2 13 CLK1 Output Clock Output 1 16 X2 Output Crystal connection Function Table OE# CLK1/CLK2/CLK3/CLK32 0 Enabled 1 Hi-Z, weak pull down 12-0164 2 www.pericom.com PI6C490097 RevA 2/06/2012 PI6C490097 PLL Clock Multiplier Maximum Ratings (Above which useful life may be impaired. For user guidelines, not tested.) Storage Temperature........................................................... -65C to +150C Supply Voltage to Ground Potential, VDD .........................-0.5V to +4.6V Note: Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. Power Requirements(Over operating free-air temperature range) Symbol Parameter Min. Typ. Max. Units VDD Power Supply Voltage 3.135 3.3 3.465 V VDDO Power Supply Voltage for outputs 1.71 3.465 V IDD Power supply current, no load TA Ambient Operating Temperature tUP Power Supply Ramp Time 20 mA 0 +70 -40 +85 C 4 ms DC Electrical Characteristics Symbol Parameter Condition Min. VIH Input High Voltage CLKIN, OE# VDD/2+1 VIL Input Low Voltage CLKIN, OE# VOH Output High Voltage VOL Output Low Voltage ZO Nominal Output Impedance R PD Internal Pull-down Resistor CIN Input Capacitance 12-0164 IOH = 4mA or -8mA Typ. Max. V VDD/2-1 V 32.768kHz output VDD032 - 0.4 V 25MHz output VDD0 - 0.4 V 0.4 IOL = 8mA OE# 230 CLKIN 320 Inputs 4 www.pericom.com PI6C490097 V W 20 3 Units kW pF RevA 2/06/2012 PI6C490097 PLL Clock Multiplier AC Electrical Characteristics Symbol Parameter FIN Input Frequency tR (Note 4) Conditions Min. Typ. Max. Units Fundamental Crystal 25 Input Clock 25 Output Rise Time 20% to 80% 25MHz, Note 1 1 ns tF Output Fall Time 80% to 20% 25MHz, Note 1 1 ns tR Output Rise Time 20% to 80% 32kHz, Note 1 2 ns tF Output Fall Time 80% to 20% 32kHz, Note 1 2 ns tDC Duty Cycle Ferror Output Frequency Synthesis Error Jphase Clock Phase Jitter (RMS) 25MHz, Note 2 0.5 Jadd Additive Jitter 25MHz, Note 3 250 MHz 50 53 0 % ppm 1.5 ps fs 1. Note 1: Measured with 7 pF load. 2. Note 2: 12 kHz to 20 MHz offset frequency using a crystal input. 3. Note 3: 12 kHz to 20 MHz offset frequency using CLKIN input with X2 floating. 4. Note 4: Do not drive this device without a crystal or valid clock input Crystal Oscillator Circuit X1 C1 20pF Crystal(CL=16pF) X2 C2 20pF CMOS Test Configuration 12-0164 4 www.pericom.com PI6C490097 RevA 2/06/2012 PI6C490097 PLL Clock Multiplier Packaging Mechanical: 16-Pin TSSOP (L) DOCUMENT CONTROL NO. PD - 1310 REVISION: E 16 DATE: 03/09/05 .169 .177 1 1 .0256 BSC 0.65 .193 .201 4.9 5.1 4.3 4.5 .004 .008 .047 max. 1.20 .002 .006 .007 .012 0.09 0.20 0.45 .018 0.75 .030 SEATING PLANE .252 BSC 6.4 0.05 0.15 0.19 0.30 Pericom Semiconductor Corporation 3545 N. 1st Street, San Jose, CA 95134 1-800-435-2335 * www.pericom.com Note: 1. Package Outline Exclusive of Mold Flash and Metal Burr 2. Controlling dimentions in millimeters 3. Ref: JEDEC MO-153F/AB DESCRIPTION: 16-Pin, 173-Mil Wide, TSSOP PACKAGE CODE: L Ordering Information Ordering Code Package Code Package Type Operating Temperature PI6C490097LE L Pb-free & Green, 16-pin TSSOP Commercial PI6C490097LIE L Pb-free & Green, 16-pin TSSOP Industrial Notes: * Thermal characteristics can be found on the company web site at www.pericom.com/packaging/ * E = Pb-free and Green * X suffix = Tape/Reel Pericom Semiconductor Corporation * 1-800-435-2336 12-0164 5 www.pericom.com PI6C490097 RevA 2/06/2012