SPECIFICATION CONTROL DRAWING
CHEMINAX Date:
Revision:
THIS SPECIFICATION SHEET FORMS A PART OF THE LATEST ISSUE OF RAYCHEM SPECIFICATION 1200.
CONSTRUCTION DETAILS ELECTRICAL CHARACTERISTICS
DIMENSIONS ARE NOMINAL VALUES IN INCHES, UNLESS
OTHERWISE DESIGNATED.
ADDITIONAL REQUIREMENTS
Designate outer jacket color with a dash number in accordance
with MIL-STD-681. Unless otherwise specified, outer jacket color
will be translucent white designated by a "-9X" appended to the
part number, (e.g. 0024J0024-9X).
Other codes and suffixes may be added to the part number, as
necessary, to capture any additional requirements imposed b y
the purchase order.
ENGINEERING REFERENCE
Users should evaluate the suitability of thi s pro du ct fo r their application. Speci fic ations are subject to ch an ge without notice. Tyco Electronics Corporation also
reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer.
Page 1 of 1 Cheminax, Raychem, TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.
Raychem Wire & Cable
501 Oakside Avenue
Redwood City, California 94063-3800
Phone: 1-800-227-8816 Fax: 1-650-361-6297
THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN.
REFERENCED DOCUMENTS SHALL B E OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID.
© 2006-2016 Tyco Electronics Corporation. All rights reserved.
0024J0024
100 OHM, AWG 24, 19 STRANDS OF AWG 36, TWINAXIAL CABLE 5-25-16
D
CHARACTERISTIC IMPEDANCE 100 ohms (nominal), Method C at 1 MHz
MUTUAL CAPACITANCE 12.5 pF/ft. (nominal)
VELOCITY OF PROPAGATION 79% (nominal)
ATTENUATION 2.3 dB/100 ft. (nominal) at 10 MHz
ELECTRICAL
CONDUCTOR RESISTANCE 26.5 ohms/1000 ft. (nominal)
(prior to cabling)
INSULATION RESISTANCE 10,000 megohms (minimum) for 1000 ft.
JACKET FLAWS
SPARK TEST 1.0 kV (rms)
IMPULSE TEST 6.0 kV (peak)
VOLTAGE WITHSTAND (DIELECTRIC) 1500 volts (rms)
ENVIRONMENTAL
FLAMMABILITY Method B
HEAT SHOCK 225°C
LOW TEMPERATURE-COLD BEND -55°C/4.25 inch mandrel
VOLTAGE WITHSTAND 1000 volts (rms), 1 minute
(Post Environmental)
PHYSICAL
INSULATION (DIELECTRIC)
(prior to cabling)
ELONGATION 50% (minimum)
TENSILE STRENGTH 600 lbf/in2 (minimum)
JACKET
ELONGATION 200% (minimum)
TENSILE STRENGTH 2000 lbf/in2 (minimum)
JACKET THICKNESS .010 inch (nominal)
WRAP .002 inch thick (nominal),
25% overlap (minimum),
Aluminum side facing in
WEIGHT 13.1 lbs/1000 ft. (nominal)
TEMPERATURE RATING 150°C (maximum)
.0250
.130
.061
.150
CONDUCTORS
AWG 24,
19 Strands of AWG 36,
Silver-Coated High-
Strength Copper Alloy
DIELECTRICS
Foamed FEP
Colors - Light Blue/White
WRAP
Aluminum PET
JACKET
Modified FEP
DRAIN WIRE
AWG 24,
19 Strands of AWG 36,
Silver-Coated High-
Strength Copper Alloy
