PRODUCT DATASHEET 1-800-383-7323 1-800-383-7323 / USA USA/CAN 1-800-383-7323 / CANADA www.energizer.com ENERGIZER 397/396 SILVER OXIDE Specifications Chemical System: Designation: Nominal Voltage: Typical Capacity: Capacity Test: Typical Weight: Typical Volume: Impedance (40 Hz): Industry Standard Dimensions mm (inches) Silver Oxide (Zn/Ag2O) ANSI-1164SO/1163SO, IEC-SR59 1.55 Volts 33 mAh* (to 1.2 volts) 45K ohm continuous drain at 21C 0.5 grams (0.018 oz.) 0.13 cubic centimeters (0.008 cubic inch) 15 to 25 ohms * Varies according to the applied load, temperature, and cutoff voltage. 3.00 (0.118) Minimum 2.60 (0.102) 2.30 (0.091) 2.33 (0.092) Ref. 2.08 (0.082) Ref. Anode Cap Gel Anode Gasket Can Separator SO L 0.25 (0.010) Maximum Ref. Permissible deflection from a flat 0.08 (0.003) Minimum Ref. (applies to top edge of gasket or edge of crimp, whichever is higher) E R0.64 (0.025) Ref. Typical Cross Section ET 7.90 (0.311) 7.55 (0.297) Cathode DESIGNED FOR USE ON CONTINUOUS LOW DRAIN HIGH PULSE ON DEMAND Temperature Characteristics Typical Performance at 21C (70F) Typical Performance at Low Discharge Rates 1.7 1.6 1.5 1.4 1.3 1.2 1.1 1.0 Service Effects 125 100 75 50 25 0 -20 0 250 Schedule Continuous 500 Service, Hours 750 1000 Typical Drains at 1.53V (milliamperes) (ohm) Cutoff 1.2V (hours) 0.034 45K 971 Load 0 20 Temperature (C) 40 Storage Effects 100 Service (%) Voltage, CCV Schedule: Continuous Typical Drain @1.53V: 0.034 milliamperes Load: 45K ohm Service (%) OB Typical Discharge Characteristics 0 C 90 20 C 80 70 40 C 60 0 2 4 6 8 Storage Time (yrs) 10 12 Important Notice This datasheet contains typical information specific to products manufactured at the time of its publication. (c)Energizer Holdings, Inc. - Contents herein do not constitute a warranty. Form No. EBC - 4354B Page 1 of 1