2 APEMwww.apem.com
IR series
Sealed momentary pushbutton switches - bushing Ø 16 - standard version
Distinctive features and specifications
❑❑ Illuminated and non-illuminated
❑❑ Tactile feedback
❑❑ Flat round actuator for optional marking
❑❑ Sealed to IP67
❑❑ Screw version up to 4A
ENVIRONMENTAL SPECIFICATIONS
• Degree of protection : IP67
• Shock resistance : 100 g according to IEC 512-4, test 6c
• Vibration resistance : 10-500Hz - 10 g according to IEC 512-4, test 6d
• Salt spray : IEC 512-6, test 11f
• Robustness (non-illuminated switch) : IK06 according to EN 50102 (1 joule)
• Operating temperature : -40°C to +85°C
ELECTRICAL SPECIFICATIONS
• Max. current/voltage rating with resistive load :
- Gold plated silver contacts (code 4) : 200mA 48VDC - 200mA 250VAC
- Silver contacts (code 2) - screw terminals : 2A 250VAC - 4A 48VDC
• Electrical life at full load : 500.000 cycles
• Initial contact resistance : 100 mΩ max.
• Insulation resistance : 1 GΩ min. at 500VDC
• Dielectric strength : 1.500 Vrms
• Contact bounce : 10 ms
MATERIALS
• Case : thermoplastic UL94-V0
• Plunger :
polyamide
6/6
• Bushing/bezel : polyamide 6/6
• Contacts :
4: silver, gold plated
2: silver (screw terminals)
• Multi-wire lead AWG20,
section 0,6 mm2, UL approved
• LED wire : AWG26
• Lens : polycarbonate
• Terminal seal : epoxy
GENERAL SPECIFICATIONS
• Panel thickness : 8 mm (.314) max.
• Total travel : 1,7 mm (.066)
• Operating force : 2N to 5N
• Mechanical life : 1.000.000 cycles
• Torque : 0,8 Nm max. applied to nut
• Soldering : 320°C max. for 3 sec.
LED COMPONENT SPECIFICATIONS
LED colour
Forward current
Super red (L0S) 20mA
20mA
20mA
20mA
Typ. forward voltage Max. forward voltage
2,1V
2,1V
2,1V
3,2V
Yellow (L0Y)
Green (L0G)
Blue (L0B)
20mA 3,35V
2,3V
2,3V
2,3V
3,8V
4,25VWhite (L0W)
A resistor must be series-connected by the user.
Resistor value = supply voltage - LED forward voltage
LED forward current
On wire lead versions, the LED resistor can be integrated by APEM on
request.
Dimensions, specifications and data shown in this brochure are subject to change without notice.
Tolerance : The general tolerance for
dimensions in this brochure is ± 0,3 (.012).
Overall dimension tolerance is ± 0,5 (.020).