REV. 6/3/05 |__ 635 [16.13] MAX -| UU PATENYED Tb WU NG (=J rl | In ae ye if & & & JL HU PIN POSITION LAYOUT IS IDENTICAL TO STANDARD JACKS 850 [21.59] MAX | g = \ al & = | @ i oO; = L c r | ! | of 040 [1.02] ~} | .050 [1.27] 3 6.036 [0.89] +.003 [.08] (8) Pe tain 3 mil ran Usd te 7S \ | & be- whe L 9 128 [325] (9) PIN # 1 *725 [3.18] [ [soos [0x5] _@ 4 eam] OF 0.065 [1.65] son [0.08] (2) 080 Foc | 053] g 450 [11.43] 3 610 [15.49] 8 P.C.B. RECOMMENDED HOLE LAYOUT SEEN FROM COMPONENT SIDE ALL CENTERLINE DIMENSIONS ARE BASIC. | | DATE REV ECN APPD. BY 2/2/06 | a3 | 7457 JM 3/n/on | a4 | 7549 SAW NOTES: 1. CONNECTOR MATERIALS: HOUSING: THERMOPLASTIC UL94 V-0 CONTACTS/SHIELD: COPPER ALLOY SHIELD PLATING: NICKEL OR TIN CONTACT PLATING: SELECTIVE GOLD IN CONTACT AREA SEE CHART FOR PART NUMBER 2. FOR PRODUCT SPECIFICATIONS SEE PRO22-01. 3. DIMENSIONS AND TOLERANCES COMPLY WITH FCC/CFR 47, PART 68. 4, DESIGNED FOR CATEGROY 5/5e APPLICATIONS. 50 MICRO-INCHES [1.27um] SS/7188SA-NF-1-50 30 MICRO-INCHES [0.76um] SS/188SA-NF- 1 CONTACT PLATING IN MATING AREA PART NUMBER THIRD ANGLE PROJECTION Bel Stewart Connector 11118 Susquehanna Trail South Glen Rock, PA 17327-9199 (717) 235-7512 Fax: (717) 235-7954 http: //www.stewartconnector.com DO NOT SCALE DRAWING DRAWING IS SUBJECT TO CHANGE WITHOUT NOTICE * EIGHT CONTACT, EIGHT POSITION, SHIELDED JACK NON-FLANGED, ALTERNATE SOLDER TAIL DIMENSIONS: INCHES [METRIC] UNLESS OTHERWISE SPECIFIED TOLERANCES ARE +.005 [0.13] ANGLES ARE + 1 SHEET NO. 1 OF 1 THIS DRAWING AND THE SUBJECT MATTER SHOWN THEREON | PRN BY: DATE ARE CONFIDENTIAL AND THE PROPRIETARY PROPERTY OF KRL 3/20/06 BEL STEWART CONNECTOR AND SHALL NOT BE REPRODUCED, | APPD BY: SAW ATE 3-21-06 COPIED, OR USED IN ANY MANNER WITHOUT PRIOR WRITTEN CONSENT OF BEL STEWART CONNECTOR. THE SUBJECT [DWG NO. REV. MATTER MAY BE PATENTED OR A PATENT MAY BE PENDING. CT/10065 A4 i AutoCAD