NEW 3mm Round (R) OptopipeTM Optical Light Pipe and Light Shield, 3 Array 515-1020-805 16.26 [.640] 6.35 [.250] 3.61 [.142] 13.06 [.514] 3.18 [.125] 3.56 [O.140] 2.39 [.094] 3.00 [.118] 6.35 [.250] 3.56 [.140] NOTE: C.L. of LED DIRECTION OF LIGHT NOTE: designed for post-reflow PC board insertion. 2.00 [.079] TYP; (2) PLACES 1.70 [.067] 1.45 [.057] 1.52 [.060] 4.19 [.165] Recommended MicroLED SMT LEDs for use with 515-1020-805 PART NO. COLOR PAGE # 597-3111-4xx 597-3201-4xx 597-3311-4xx 597-3401-4xx AlGaAs Red Orange Green Yellow 1-28 1-28 1-28 1-28 1.35 [.053] 1.93 [.076 .002] Dimensions in mm [inches] 2.34 [.092] 8.69 [.342] 4.01 [.158] RECOMMENDED PIN HOLES AND SOLDER PAD LAYOUT FOR SUGGESTED MicroLED LEDs COMPONENT SIDE OF PRINTED CIRCUIT BOARD Features * High transmissivity polycarbonate material * UL94V-0 compliance * ESD protection (circuit isolation from front panel) LED Data For absolute maximum ratings and other electrical and optical data on the recommended LEDs, refer to LED data sheets. * Wide viewing angle * Arrays reduce insertion costs Operating/Storage Temperature * Secures to PCB by press-fit -30C to +100C Dialight Optopipe Light Pipe Description This light pipe's circular light emitting surfaces appear bright and have good optical isolation. It is reliably held in place by 2 press-fit pins located between the light pipe elements. This OptopipeTM functions as a through-the-case indicator with a textured finish on the 3 light emitting surface that increases its viewing angle. The LEDs are mounted in a straight line on a 0.250" pitch. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom OptopipeTM solutions for your applications. Dialight Corporation * 1501 Route 34 South * Farmingdale, NJ 07727 * TEL: (732) 919-3119 * FAX: (732) 751-5778 *www.dialight.com 2-39 2