Model RFP-250250N4AAXX Surface Mount Attenuator 10 Watts Description The RFP-250250N4AAXX is high performance Aluminum Nitride (AlN) surface mount attenuator intended as a lower cost alternative to Beryllium Oxide (BeO). The attenuator is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for inter-stage matching, directional couplers, and for use in isolators. General Specifications Features: * Low Cost * Surface Mount * Aluminum Nitride Ceramic * Non-Nichrome Resistive Element * Low VSWR * 100% Tested Resistive Element Substrate Terminal Finish Operating Temperature Thick film Aluminum Nitride Ceramic Matte Tin over Sulfamate Nickel -55 to +125C (see chart) Tolerance is 0.010", unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Electrical Specifications Attenuation Value: Power: Frequency Range: V.S.W.R.: 1 - 6, 9, 10dB 10 Watts DC - 2.0 GHz <1.25:1 Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change. Outline Drawing Dimensions given in inches. Rev. 3/3/06 Available on Tape and Reel For Pick and Place Manufacturing. USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model RFP-250250N4AAXX Specifications: PART NUMBER ATTENUATION(dB) TOL. (dB) POWER (WATTS) VSWR FREQ (GHZ) RFP-250250N4AA1 1 0.2 10 1.25:1 2.0 RFP-250250N4AA2 2 0.3 10 1.25:1 2.0 RFP-250250N4AA3 3 0.3 10 1.25:1 2.0 RFP-250250N4AA4 4 0.3 10 1.25:1 2.0 RFP-250250N4AA5 5 0.3 10 1.25:1 2.0 RFP-250250N4AA6 6 0.4 10 1.25:1 2.0 RFP-250250N4AA9 9 0.6 10 1.25:1 2.0 RFP-250250N4AA10 10 0.7 10 1.25:1 2.0 Power De-rating: Tape & Reel: Mounting Footprint and Procedure: USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Available on Tape and Reel For Pick and Place Manufacturing.