SURFACE MOUNT DISPLAY P/N: KPSC03-101 Features HIGH EFFICIENCY RED Description 0.3 INCH DIGIT HEIGHT. The High Efficiency Red source color devices are LOW CURRENT OPERATION. made with Gallium Arsenide Phosphide on Gallium EXCELLENT CHARACTER APPEARANCE. Phosphide Orange Light Emitting Diode. I.C. COMPATIBLE. MECHANICALLY RUGGED. GRAY FACE,WHITE SEGMENT. PACKAGE : 550PCS / REEL. RoHS COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAB6201 REV NO: V.5 APPROVED: J. Lu CHECKED: Joe Lee DATE: NOV/19/2005 DRAWN: Y.L.LI PAGE: 1 OF 4 Selection Guide Part No. Dice KPSC03-101 Iv (ucd) @ 10 mA Lens Type HIGH EFFICIENCY RED(GaAsP/GaP) WHITE DIFFUSED Description Min. Typ. 1200 4210 Common Cathode, Rt. Hand Decimal. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. peak Peak Wavelength High Efficiency Red D Dominant Wavelength 1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating/Storage Temperature -40C To +85C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAB6201 REV NO: V.5 APPROVED: J. Lu CHECKED: Joe Lee DATE: NOV/19/2005 DRAWN: Y.L.LI PAGE: 2 OF 4 High Efficiency Red KPSC03-101 SPEC NO: DSAB6201 REV NO: V.5 APPROVED: J. Lu CHECKED: Joe Lee DATE: NOV/19/2005 DRAWN: Y.L.LI PAGE: 3 OF 4 KPSC03-101 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, Luminous intensity/ luminous flux, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous intensity/ Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAB6201 REV NO: V.5 APPROVED: J. Lu CHECKED: Joe Lee DATE: NOV/19/2005 DRAWN: Y.L.LI PAGE: 4 OF 4