SPEC NO: DSAB6201 REV NO: V.5 DATE: NOV/19/2005 PAGE: 1 O F 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI
SURFACE MOUNT DISPLAY
Features
0.3 INCH DIGIT HEIGHT.
LOW CURRENT OPERATION.
EXCELLENT CHARACTER APPEARANCE.
I.C. COMPATIBLE.
MECHANICALLY RUGGED.
GRAY FACE,WHITE SEGMENT.
PACKAGE : 550PCS / REEL.
RoHS COMPLIANT.
Package Dimensions & Internal Circuit Diagram
Notes:
1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted.
2. Specifications are subject to change without notice.
Description
The High Efficiency Red source color devices are
made with Gallium Arsenide Phosphide on Gallium
Phosphide Orange Light Emitting Diode.
P/N: KPSC03-101 HIGH EFFICIENCY RED
SPEC NO: DSAB6201 REV NO: V.5 DATE: NOV/19/2005 PAGE: 2 O F 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI
Selection Guide
Part No. Dice Lens Type Iv (ucd)
@ 10 mA
Min. Typ.
KPSC03-101 HIGH EFFICIENCY RED(GaAsP/GaP) WHITE DIFFUSED 1200 4210 Common Cathode, Rt.
Hand Decimal.
Description
Electrical / Optical Characteristics at TA=25°C
Absolute Maximum Ratings at TA=25°C
Note:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
Parameter High Efficiency Red Units
Power dissipation 105 mW
DC Forward Current 30 mA
Peak Forward Current [1] 160 mA
Reverse Voltage 5 V
Operating/Storage Temperature -40°C To +85°C
Symbol Parameter Device Typ. Max. Test ConditionsUnits
λpeak Peak Wavelength High Efficiency Red 627 nm IF=20mA
λDDominant Wavelength High Efficiency Red 625 nm IF=20mA
∆λ1/2 Spectral Line Half-width High Efficiency Red 45 nm IF=20mA
C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz
VFForward Voltage High Efficiency Red 2.0 2.5 V IF=20mA
IRReverse Current High Efficiency Red 10 uA VR = 5V
SPEC NO: DSAB6201 REV NO: V.5 DATE: NOV/19/2005 PAGE: 3 O F 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI
High Efficiency Red KPSC03-101
SPEC NO: DSAB6201 REV NO: V.5 DATE: NOV/19/2005 PAGE: 4 O F 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI
Recommended Soldering Pattern
(Units : mm)
Tape Specifications
(Units : mm)
Remarks:
If special sorting is required (e.g. binning based on forward voltage, Luminous intensity/ luminous flux, or wavelength),
the typical accuracy of the sorting process is as follows:
1. Wavelength: +/-1nm
2. Luminous intensity/ Luminous Flux: +/-15%
3. Forward Voltage: +/-0.1V
Note: Accuracy may depend on the sorting parameters.
KPSC03-101
