CV92/CV34/CV22
Complete Embedded Data Modems
Product Brief
FEATURES
n Two-chip modem solution:
— CVxx Modem Device in 48-pin TQFP or
100-pin FSBGA (CV92-F100 only)
— CSP1040 DAA in 20-pin ETSSOP
n Data mode capabilities:
— V.92, V.90, V.34, V.32bis, V.32, V.22bis,
V.22. V.21, Bell 212A, Bell 103
— V.17 and lower fax rates
— V.44, V.42bis, MNP 5 Data Compression
— V.42, MNP 2–4 Error Correction
n CVxx Modem Device features:
— ARM7TDMS Microcontroller
— DSP1600S Digital Signal Processor
— DAA interface and lters
— Host interface congurable for 8-bit parallel,
asynchronous serial or SPI mode
— On-chip PWM speaker driver
— SIO interface for audio codec used in voice and
handset applications
— 24.576 MHz crystal or external 27.0 MHz clock
n CSP1040 DAA features:
— Derives power from system for reliable
operation on all phone lines
— Digital transformer isolation barrier
— Programmable event detect for caller-ID
reception and power ring detection
— Programmable pulse shaping and spark quench
— Programmable dc-impedance
termination for country-specic VI templates
— Programmable ac-impedance termination for
return loss matching
— Programmable ringer-impedance emulation
— Hardware support for pulse dialing for accurate
make/break timing.
— Hardware support for ringing level and
frequency qualication for accurate
ring detection.
— Line-in-use and remote handset detection
— World-wide caller ID support
n Single 3.3V supply required for chip set.
The CVxx family of devices is designed to serve embedded applications
that require high-speed dial-up data connections. There are several ver-
sions available based on modulations and other features.
For designs that must support eld-upgrade-
ability or customized features, a version of the
CV92 device is available in a 100 FSBGA that
can support external ash ROM. All other ver-
sions run from on-chip ROM. The table on page
* Actual speeds over U.S. telephone lines vary and are less than 56K due to current FCC regulations and line conditions.
Figure 1 shows a reference design using the 48-pin CVxx and the CSP1040. This is a 2-layer PCB with components on top-
side only. The layout can be integrated into a larger PCB or built as a separate module with connectors.
2 shows the features supported for the various
versions. The CVxx devices support RS232 and
8-bit microprocessor interfaces. Additionally,
the CVxx devices can be congured for opera-
tion on a 4-wire SPI bus.