3PS8866C 03/11/09
PI2PCIE2412
1.8V, PCI Express Gen2 Compliant,
4-Differential Channel, 2:1 Mux/DeMux Switch
Storage Temperature ....................................................–65°C to +150°C
Supply Voltage to Ground Potential ................................–0.5V to +2.5V
DC Input Voltage .............................................................. –0.5V to VDD
DC Output Current ....................................................................... 120mA
Power Dissipation ...........................................................................0.5W
Note: Stresses greater than those listed under MAX I MUM
RAT INGS may cause permanent damage to the de vice. This
is a stress rating only and func tion al op er a tion of the device
at these or any other conditions above those indicated in the
operational sections of this spec i fi ca tion is not implied. Expo-
sure to absolute max i mum rating con di tions for extended
periods may affect re li abil i ty.
Maximum Ratings
(Above which useful life may be impaired. For user guide lines, not tested.)
DC Electrical Characteristics for Switching over Operating Range (TA = –40°C to +85°C, VDD = 1.5V to 2.0V)
Parameters Description Test Conditions(1) Min Typ(2) Max Units
VIH Input HIGH Voltage Guaranteed HIGH level
0.65 x
VDD
V
VIL Input LOW Voltage Guaranteed LOW level –0.5 0.35 x
VDD
VIK Clamp Diode Voltage VDD = Max., IIN = –18mA –0.7 –1.2
IIH Input HIGH Current VDD = Max., VIN = VDD ±5
μA
IIL Input LOW Current VDD = Max., VIN = GND ±5
Dynamic Electrical Characteristics Over the Operating Range (TA= -40º to +85ºC, VDD = 1.8V±10%, GND=0V)
Parameters Description Test Conditions Min. Typ.(2) Max. Units
XTALK Crosstalk See Fig. 1 for Measurement Setup, f= 3 GHz
f = 100 MHz
-23dB
-58dB dB
OIRR OFF Isolation See Fig. 2 for Measurement Setup, f= 3 GHz
f = 100 MHz
-23dB
-58dB
ILOSS Differential
Insertion Loss f= 3 GHz -2 dB
BW Bandwidth -3dB 4.1 GHz
Notes:
1. For Max. or Min. conditions, use appropriate value specifi ed under Electrical Characteristics for the applicable device type.
2. Typical values are at VDD = 1.8V, TA = 25°C ambient and maximum loading.
Power Supply Characteristics
Parameters Description Test Conditions(1) Min. Typ.(2) Max. Units
ICC Quiescent Power Supply Current VDD = Max., VIN = GND or VDD 200 μA
Switching Characteristics (TA= -40º to +85ºC, VDD = 1.8V±10%)
Parameters Description Min. Max. Units
tPZH, tPZL Line Enable Time - SEL to AN, BN, CN0.5 8.0 ns
tPHZ, tPLZ Line Disable Time - SEL to AN, BN, CN0.5 8.0
tb-b Bit-to-bit skew within the same differential pair 7ps
tch-ch Channel-to-channel skew 35 ps