7/30/2000
ON-BOARD DC-DC CONVERTER ENCAPSULATED MODULES
30 WATTS TRIPLE OUTPUT APS30DM-T SERIES
Advanced Power Solutions
FEATURES:
¢ TRIPLE OUTPUT
¢ WIDE 4:1 & 2:1 INPUT RANGE
¢ 30W ISOLATED OUTPUT
¢ SIX-SIDED METAL SHIELD
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart
Output Current: See Ratings Chart
Voltage Accuracy: Main O/P ±2.0％typ.
Line Regulation: ±0.5% typ.
Load Regulation: VO1 & VO3 ±2.0％, VO2 ±5.0% typ.
Noise & Ripple: 100mV for 3.3V/5.0V & 1.0% typ.
for other output peak to peak
OVP: Built-in on main output
Adjustability: VO1 O/P may optionally be external
trimmed ±3.0% with a fixed resistors
or trim-pot
Short Circuit Protection: Power fold back,
Self-recovering.
Overload Protection: About 130% of overrange by
foldback type
SPECIFICATION
INPUT SPECIFICATION
Input Range: Wide 4:1 & 2:1 DC input range
See Ratings Chart
Input Voltage: Nominal 12/24/48Vdc
Input Current: Various with input range and load
See Ratings Chart
Input Fuse: Use external fuse
Input Filter: Pi-Network
Overvoltage Shutdown: Optional. Factory set
Undervoltage Shutdown: 8Vdc
Isolation Resistor: 1,000 Mega Ohms
Isolation Voltage: 1,500Vdc
EMI: Six-sided metal shielding
Remote On/Off: TTL/CMOS-Compatible Input Control
Logic input reference to –input/-Vin
Logic [1]/Open(or 2.5-7.0Vdc above-Vin)=ON
Logic [2]/Short(or 0-0.08Vdc above-Vin)=OFF
GENERAL SPECIFICATION
Efficiency: Typ. 81％, various with input
Switching Frequency: Fixed frequency 100K Hz
Circuit Topology: 100K Hz. Forward Circuit
Transient Response: Full to 1/2 load <200µsec.
Case: Black coated copper with non-conductive
metal base
Weight: 156.0g (5.6 Oz.)
Power Density: 10.0 Watts./ Cubic inch
Operating Temperature: -25°C to +71°C range
–20°C to +60°C @ full load without derating
Temperature: -40°C to +105°C
Temperature Coefficient: 0.02% /°C
Cooling: Convection cooling up to +60°C @ full load
At least 100LFM moving air is recommended for F-L
> +60°C in a confined area
Humidity: Up to 95％RH, Non-condensing
Commercial Grade only
NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise specified.
(2) Line Regulation measured from High to Low Lines at full load.
(3) Load Regulation measured from Full Load to 1/2 Full Load at nominal input.
(4) Correct fuse size by calculating the max. DC current drain at low Line input & Load and then adding 20-25％for the desired fuse size.
INPUT/OUTPUT & VOLTAGE/CURRENT RATINGS CHART
TRIPLE OUTPUT
INPUT CURRENT OUTPUT(Vdc) OUTPUT(A)
MODEL NO. INPUT
Vdc N.L. (mA) F.L. +VO1 +VO2 -VO3 +VO1 +VO2 -VO3
CASE
SIZE
APS30DM-12B-T5/12 9.0- 18.0 50 2,550 +5.0V +12.0V -12.0V 2.5A 0.5A 0.5A DM2A
APS30DM-12B-T5/15 9.0- 18.0 50 2,550 +5.0V +15.0V -15.0V 2.5A 0.4A 0.4A DM2A
APS30DM-12B-T5/+12,-5 9.0- 18.0 50 2,500 +5.0V +12.0V - 5.0V 2.5A 0.5A 1.0A DM2A
APS30DM-24B-T5/12 18.0- 36.0 40 1,520 +5.0V +12.0V -12.0V 3.0A 0.6A 0.6A DM2A
APS30DM-24B-T5/15 18.0- 36.0 40 1,550 +5.0V +15.0V -15.0V 3.0A 0.5A 0.5A DM2A
APS30DM-24B-T5/+12,-5 18.0- 36.0 40 1,420 +5.0V +12.0V - 5.0V 3.0A 0.6A 1.0A DM2A
APS30DM-48B-T5/12 36.0- 72.0 40 760 +5.0V +12.0V -12.0V 3.0A 0.6A 0.6A DM2A
APS30DM-48B-T5/15 36.0- 72.0 40 775 +5.0V +15.0V -15.0V 3.0A 0.5A 0.5A DM2A
APS30DM-48B-T5/+12,-5 36.0- 72.0 40 710 +5.0V +12.0V - 5.0V 3.0A 0.6A 1.0A DM2A
APS30DM-12D-T5/12 9.0- 36.0 40 2,650 +5.0V +12.0V -12.0V 2.5A 0.5A 0.5A DM2A
APS30DM-12D-T5/15 9.0- 36.0 40 2,650 +5.0V +15.0V -15.0V 2.5A 0.4A 0.4A DM2A
APS30DM-12D-T5/+12,-5 9.0- 36.0 40 2,600 +5.0V +12.0V - 5.0V 2.5A 0.5A 1.0A DM2A
APS30DM-24D-T5/12 9.0- 36.0 60 1,325 +5.0V +12.0V -12.0V 2.5A 0.5A 0.5A DM2A
APS30DM-24D-T5/15 9.0- 36.0 60 1,325 +5.0V +15.0V -15.0V 2.5A 0.4A 0.4A DM2A
APS30DM-24D-T5/+12,-5 9.0- 36.0 60 1,300 +5.0V +12.0V - 5.0V 2.5A 0.5A 1.0A DM2A
APS30DM-48D-T5/12 20.0- 72.0 50 785 +5.0V +12.0V -12.0V 3.0A 0.6A 0.6A DM2A
APS30DM-48D-T5/15 20.0- 72.0 50 800 +5.0V +15.0V -15.0V 3.0A 0.5A 0.5A DM2A
APS30DM-48D-T5/+12,-5 20.0- 72.0 50 735 +5.0V +12.0V - 5.0V 3.0A 0.6A 1.0A DM2A
MECHANICAL DIMENSIONS: MM [INCHES] Weight: 156.0g (5.6 Oz.)
APS30DM-T
PIN ASSIGNMENT
PIN NO. TRIPLE
PIN# 1. Remote ON/OFF
PIN# 2. +INPUT
PIN# 3. - INPUT/-Vin
PIN# 4. NC
PIN# 5. +VO2
PIN# 6. DC-COM
PIN# 7. -VO3
PIN# 8. + VO1
PIN# 9. NC
PIN# 10. OUTPUT TRIM
CASE SIZE: DM2A
