Advanced Power Solutions 7/30/2000 ON-BOARD DC-DC CONVERTER ENCAPSULATED MODULES 30 WATTS TRIPLE OUTPUT APS30DM-T SERIES FEATURES: TRIPLE OUTPUT WIDE 4:1 & 2:1 INPUT RANGE 30W ISOLATED OUTPUT SIX-SIDED METAL SHIELD SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Input Range: Wide 4:1 & 2:1 DC input range See Ratings Chart Input Voltage: Nominal 12/24/48Vdc Input Current: Various with input range and load See Ratings Chart Input Fuse: Use external fuse Input Filter: Pi-Network Overvoltage Shutdown: Optional. Factory set Undervoltage Shutdown: 8Vdc Isolation Resistor: 1,000 Mega Ohms Isolation Voltage: 1,500Vdc EMI: Six-sided metal shielding Remote On/Off: TTL/CMOS-Compatible Input Control Logic input reference to -input/-Vin Logic [1]/Open(or 2.5-7.0Vdc above-Vin)=ON Logic [2]/Short(or 0-0.08Vdc above-Vin)=OFF Output Voltage: See Ratings Chart Output Current: See Ratings Chart Voltage Accuracy: Main O/P 2.0typ. Line Regulation: 0.5% typ. Load Regulation: VO1 & VO3 2.0, VO2 5.0% typ. Noise & Ripple: 100mV for 3.3V/5.0V & 1.0% typ. for other output peak to peak OVP: Built-in on main output Adjustability: VO1 O/P may optionally be external trimmed 3.0% with a fixed resistors or trim-pot Short Circuit Protection: Power fold back, Self-recovering. Overload Protection: About 130% of overrange by foldback type GENERAL SPECIFICATION Efficiency: Typ. 81, various with input Switching Frequency: Fixed frequency 100K Hz Circuit Topology: 100K Hz. Forward Circuit Transient Response: Full to 1/2 load <200sec. Case: Black coated copper with non-conductive metal base Weight: 156.0g (5.6 Oz.) Power Density: 10.0 Watts./ Cubic inch Operating Temperature: -25C to +71C range -20C to +60C @ full load without derating Temperature: -40C to +105C Temperature Coefficient: 0.02% /C Cooling: Convection cooling up to +60C @ full load At least 100LFM moving air is recommended for F-L > +60C in a confined area Humidity: Up to 95RH, Non-condensing Commercial Grade only NOTE: (1) All mea su rements a re a t nomina l inpu t, fu ll loa d, a nd + 2 5 C unless otherwise specified. (2) Line Regulation measured from High to Low Lines at full load. (3) Load Regulation measured from Full Load to 1/2 Full Load at nominal input. (4) Correct fuse size by calculating the max. DC current drain at low Line input & Load and then adding 20-25for the desired fuse size. INPUT/OUTPUT & VOLTAGE/CURRENT RATINGS CHART TRIPLE OUTPUT MODEL NO. APS30DM-12B-T5/12 APS30DM-12B-T5/15 APS30DM-12B-T5/+12,-5 APS30DM-24B-T5/12 APS30DM-24B-T5/15 APS30DM-24B-T5/+12,-5 APS30DM-48B-T5/12 APS30DM-48B-T5/15 APS30DM-48B-T5/+12,-5 APS30DM-12D-T5/12 APS30DM-12D-T5/15 APS30DM-12D-T5/+12,-5 APS30DM-24D-T5/12 APS30DM-24D-T5/15 APS30DM-24D-T5/+12,-5 APS30DM-48D-T5/12 APS30DM-48D-T5/15 APS30DM-48D-T5/+12,-5 INPUT Vdc 9.0- 18.0 9.0- 18.0 9.0- 18.0 18.0- 36.0 18.0- 36.0 18.0- 36.0 36.0- 72.0 36.0- 72.0 36.0- 72.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 9.0- 36.0 20.0- 72.0 20.0- 72.0 20.0- 72.0 INPUT CURRENT N.L. (mA) F.L. 50 2,550 50 2,550 50 2,500 40 1,520 40 1,550 40 1,420 40 760 40 775 40 710 40 2,650 40 2,650 40 2,600 60 1,325 60 1,325 60 1,300 50 785 50 800 50 735 OUTPUT(Vdc) +VO1 +VO2 -VO3 +5.0V +12.0V -12.0V +5.0V +15.0V -15.0V +5.0V +12.0V - 5.0V +5.0V +12.0V -12.0V +5.0V +15.0V -15.0V +5.0V +12.0V - 5.0V +5.0V +12.0V -12.0V +5.0V +15.0V -15.0V +5.0V +12.0V - 5.0V +5.0V +12.0V -12.0V +5.0V +15.0V -15.0V +5.0V +12.0V - 5.0V +5.0V +12.0V -12.0V +5.0V +15.0V -15.0V +5.0V +12.0V - 5.0V +5.0V +12.0V -12.0V +5.0V +15.0V -15.0V +5.0V +12.0V - 5.0V MECHANICAL DIMENSIONS: MM [INCHES] OUTPUT(A) +VO1 +VO2 -VO3 2.5A 0.5A 0.5A 2.5A 0.4A 0.4A 2.5A 0.5A 1.0A 3.0A 0.6A 0.6A 3.0A 0.5A 0.5A 3.0A 0.6A 1.0A 3.0A 0.6A 0.6A 3.0A 0.5A 0.5A 3.0A 0.6A 1.0A 2.5A 0.5A 0.5A 2.5A 0.4A 0.4A 2.5A 0.5A 1.0A 2.5A 0.5A 0.5A 2.5A 0.4A 0.4A 2.5A 0.5A 1.0A 3.0A 0.6A 0.6A 3.0A 0.5A 0.5A 3.0A 0.6A 1.0A Weight: 156.0g (5.6 Oz.) APS30DM-T CASE SIZE: DM2A CASE SIZE DM2A DM2A DM2A DM2A DM2A DM2A DM2A DM2A DM2A DM2A DM2A DM2A DM2A DM2A DM2A DM2A DM2A DM2A PIN ASSIGNMENT PIN NO. TRIPLE PIN# 1. Remote ON/OFF +INPUT PIN# 2. - INPUT/-Vin PIN# 3. NC PIN# 4. +VO2 PIN# 5. DC-COM PIN# 6. -VO3 PIN# 7. + VO1 PIN# 8. NC PIN# 9. PIN# 10. OUTPUT TRIM