Instruction Sheet 2mm Mini-Shunt 408-3276 AMP Connectors 382575 03 JUN 98 Rev B Housing Contact 3. INSTALLING CONNECTORS Determine which posts are to be commoned. Fingers 0.5 mm [.020 In.] or tweezers may be used. Align connector over posts Square Post and push connector straight down onto posts until bottomed. Miele cae should be taken when using iweezers that excessive force is not applied to sides of connector, which could cause shunt damage. PART HOUSING CONTACT NUMBER COLOR PLATING 9825 75-2 Black 000881 [,000016) 00076 [.000030] 382575-3 Black Colle @ In contact area only. . Figure 1 1. INTRODUCTION This instruction sheet covers installation procedures for the AMP* 2mm MiniShunt Connectors listed in Figure 1. These connectors are used for mating, commoning, or shorting two 0.5mm [.020in.] square posts on 2.0mm [.079in.] centerlines. Dimensions on this sheet are in metric units [with 4. REMOVING CONNECTORS U.S, customary equivalenis in brackets}. Fingers or tweezers may be used to pull straight up on connector. Figure 2 Reasons for reissue are provided in Section 5, REVISION SUMMARY. 5. REVISION SUMMARY 2. DESCRIPTION Revisions to this document include: Each shunt connector consists of a glasstilled Per EC 0990062098 polyester housing pre-loaded with receptacle , , * Removed obsolete part numbers from Figure 1 contacts of beryllium copper material. AMP Incorporated, Harrisburg, PA 17105 TOOLING ASSISTANCE CENTER 1-800-722-1111 AMP FAX*/PRODUCT INFO 1-800-522-6752 4 of 1 This AMP controlled document is subject to change. For latest revision call the AMP FAX number. Copyright 1998 by AMP Incorporated. All Rights Reserved. LOC B Trademark Form 404-25 1/98