FS6282 Dual PLL Clock Generator IC AMERICAN MICROSYSTEMS, INC. October 1999 1.0 Features 2.0 * Dual phase-locked loop (PLL) device with three output clock frequencies * * 3.3V supply voltage Small circuit board footprint (8-pin 0.150 SOIC) * Custom frequency selections available - contact your local AMI Sales Representative for more information Figure 1: Pin Configuration 1 VSS 2 XIN 3 XOUT FS6282 CLKA 4 8 OE 7 VDD 6 CLKC Description The FS6282 is a monolithic CMOS clock generator IC designed to minimize cost and component count in digital video/audio systems. Two high-resolution phase-locked loops generate two output clocks (CLKA and CLKB) through an array of postdividers. All frequencies are ratiometrically derived from the crystal oscillator frequency. The locking of all the output frequencies together can eliminate unpredictable artifacts in video systems and reduce electromagnetic interference (EMI) due to frequency harmonic stacking. Table 1: Crystal / Output Frequencies DEVICE FS6282-03 fXIN (MHz) CLKA (MHz) CLKB (MHz) CLKC (MHz) 20.000 20.000 48.000 8.000 NOTE: Contact AMI for custom PLL frequencies 5 CLKB 8-pin (0.150 ) SOIC Figure 2: Block Diagram XIN CLKA CRYSTAL OSC. XOUT PLL DIVIDER ARRAY PLL CLKB CLKC OE FS6282 This document contains information on a preproduction product. Specifications and information herein are subject to change without notice. ISO9001 10.1.99 FS6282 Dual PLL Clock Generator IC AMERICAN MICROSYSTEMS, INC. October 1999 Table 2: Pin Descriptions Key: AI = Analog Input; AO = Analog Output; DI = Digital Input; DIU = Input with Internal Pull-Up; DID = Input with Internal Pull-Down; DIO = Digital Input/Output; DI-3 = Three-Level Digital Input, DO = Digital Output; P = Power/Ground; # = Active Low pin 3.0 PIN TYPE NAME DESCRIPTION 1 DO CLKA 2 P VSS Ground Crystal Oscillator Feedback Clock Output A 3 AI XIN 4 AO XOUT 5 DO CLKB Clock Output B 6 DO CLKC Clock Output C 7 P VDD 8 DIU OE Crystal Oscillator Drive Power (+3.3 volts) Output Enable (outputs active when OE=VDD) Electrical Specifications Table 3: Absolute Maximum Ratings Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. These conditions represent a stress rating only, and functional operation of the device at these or any other conditions above the operational limits noted in this specification is not implied. Exposure to maximum rating conditions for extended conditions may affect device performance, functionality, and reliability. PARAMETER Supply Voltage (VSS = ground) SYMBOL MIN. MAX. UNITS VDD VSS-0.5 7 V Input Voltage, dc VI VSS-0.5 VDD+0.5 V Output Voltage, dc VO VSS-0.5 VDD+0.5 V Input Clamp Current, dc (VI < 0 or VI > VDD) IIK -50 50 mA Output Clamp Current, dc (VI < 0 or VI > VDD) IOK -50 50 mA Storage Temperature Range (non-condensing) TS -65 150 C Ambient Temperature Range, Under Bias TA -55 125 C Junction Temperature TJ 125 C Lead Temperature (soldering, 10s) Input Static Discharge Voltage Protection (MIL-STD 883E, Method 3015.7) 260 C 2 kV CAUTION: ELECTROSTATIC SENSITIVE DEVICE Permanent damage resulting in a loss of functionality or performance may occur if this device is subjected to a high-energy electrostatic discharge. Table 4: Operating Conditions PARAMETER SYMBOL Supply Voltage VDD Ambient Operating Temperature Range TA CONDITIONS/DESCRIPTION 3.3V 10% MIN. TYP. MAX. 3.0 3.3 3.6 V 70 C 0 UNITS 2 ISO9001 10.1.99 FS6282 Dual PLL Clock Generator IC AMERICAN MICROSYSTEMS, INC. October 1999 Table 5: DC Electrical Specifications Unless otherwise stated, VDD = 3.3V 10%, no load on any output, and ambient temperature range TA = 0C to 70C. Parameters denoted with an asterisk ( * ) represent nominal characterization data and are not production tested to any specific limits. Where given, MIN and MAX characterization data are 3 f rom typical. Negative currents indicate current flows out of the device. PARAMETER SYMBOL CONDITIONS/DESCRIPTION MIN. TYP. MAX. UNITS Overall Supply Current, Dynamic, with Loaded Outputs IDD fXTAL = 13.5MHz; CL = 10pF, VDD = 3.6V 30 mA As seen by a crystal connected to XIN and XOUT 18 pF Crystal Oscillator Crystal Loading Capacitance CL(xtal) Clock Outputs (CLKA, CLKB) zOH VO = 0.1VDD; output driving high 45 zOL VO = 0.1VDD; output driving low 45 Short Circuit Source Current * IOSH VO = 0V; shorted for 30s, max. -35 mA Short Circuit Sink Current * IOSL VO = 3.3V; shorted for 30s, max. 35 mA Output Impedance * Table 6: AC Timing Specifications Unless otherwise stated, VDD = 3.3V 10%, no load on any output, and ambient temperature range TA = 0C to 70C. Parameters denoted with an asterisk ( * ) represent nominal characterization data and are not production tested to any specific limits. Where given, MIN and MAX characterization data are 3 f rom typical. PARAMETER SYMBOL CONDITIONS/DESCRIPTION MIN. TYP. MAX. UNITS 0 ppm 55 % Overall Synthesis Error (unless otherwise noted in Frequency Table) Clock Outputs (CLKA, CLKB, CLKC) Ratio of high pulse width (as measured from rising edge to next falling edge at VDD/2) to one clock period Duty Cycle * Jitter, Period (peak-peak) * tj(P) From rising edge to next rising edge at VDD/2, CL = 10pF 45 300 ps Rise Time * tr VDD = 3.3V; VO = 0.3V to 3.0V; CL = 10pF 3 ns Fall Time * tf VDD = 3.3V; VO = 3.0V to 0.3V; CL = 10pF 2.5 ns 3 ISO9001 10.1.99 FS6282 Dual PLL Clock Generator IC AMERICAN MICROSYSTEMS, INC. October 1999 4.0 Package Information Table 7: 8-pin SOIC (0.150") Package Dimensions 8 DIMENSIONS INCHES MILLIMETERS MIN. MAX. MIN. MAX. A 0.061 0.068 1.55 1.73 A1 0.004 0.0098 0.102 0.249 A2 0.055 0.061 1.40 1.55 B 0.013 0.019 0.33 0.49 C 0.0075 0.0098 0.191 0.249 D 0.189 0.196 4.80 4.98 E 0.150 0.157 3.81 3.99 e 0.050 BSC 0.230 0.244 5.84 6.20 h 0.010 0.016 0.25 0.41 L 0.016 0.035 0.41 0.89 0 8 E H 1 ALL RADII: 0.005" TO 0.01" h x 45 B 7 typ. e 1.27 BSC H R AMERICAN MICROSYSTEMS, INC. 0 A2 A D A1 BASE PLANE 8 C L SEATING PLANE Table 8: 8-pin SOIC (0.150") Package Characteristics PARAMETER SYMBOL Thermal Impedance, Junction to Free-Air 8-pin 0.150" SOIC JA Lead Inductance, Self L11 CONDITIONS/DESCRIPTION TYP. UNITS Air flow = 0 m/s 110 C/W Corner lead 2.0 Center lead 1.6 nH Lead Inductance, Mutual L12 Any lead to any adjacent lead 0.4 nH Lead Capacitance, Bulk C11 Any lead to VSS 0.27 pF 4 ISO9001 10.1.99 FS6282 Dual PLL Clock Generator IC AMERICAN MICROSYSTEMS, INC. October 1999 5.0 Ordering Information ORDERING CODE DEVICE NUMBER PACKAGE TYPE OPERATING TEMPERATURE RANGE SHIPPING CONFIGURATION 11640-828 FS6282-03 8-pin (0.150") SOIC (Small Outline Package) 0 C to 70 C (Commercial) Tape and Reel 11640-838 FS6282-03 8-pin (0.150") SOIC (Small Outline Package) 0 C to 70 C (Commercial) Tubes Copyright (c) 1999 American Microsystems, Inc. Devices sold by AMI are covered by the warranty and patent indemnification provisions appearing in its Terms of Sale only. AMI makes no warranty, express, statutory implied or by description, regarding the information set forth herein or regarding the freedom of the described devices from patent infringement. AMI makes no warranty of merchantability or fitness for any purposes. AMI reserves the right to discontinue production and change specifications and prices at any time and without notice. AMI's products are intended for use in commercial applications. Applications requiring extended temperature range, unusual environmental requirements, or high reliability applications, such as military, medical life-support or life-sustaining equipment, are specifically not recommended without additional processing by AMI for such applications. American Microsystems, Inc., 2300 Buckskin Rd., Pocatello, ID 83201, (208) 233-4690, FAX (208) 234-6796, WWW Address: http://www.amis.com E-mail: tgp@amis.com 5 ISO9001 10.1.99