2PS8921B 08/20/09
PI2DBS212
2.0GHz, Differential Broadband Signal Switch,
2-Differential Channel, 2:1 Mux/DeMux Switch
Storage Temperature....................................–65°C to +150°C
Supply Voltage to Ground Potential...............–0.5V to +2.5V
DC Input Voltage ............................................–0.5V to VDD
DC Output Current......................................................120mA
Power Dissipation...........................................................0.5W
Note:
Stresses greater than those listed under MAX I MUM RAT INGS may cause
permanent damage to the de vice. This is a stress rating only and func-
tion al op er a tion of the device at these or any other conditions above those
indicated in the operational sections of this spec i fi ca tion is not implied.
Exposure to absolute max i mum rating con di tions for extended periods
may affect re li abil i ty.
Maximum Ratings
(Above which useful life may be impaired. For user guide lines, not tested.)
DC Electrical Characteristics over 1.8V Operating Range (TA= -40°C to +85°C, VDD = 1.8V ±10%)
Parameter Description Test Conditions(1) Min. Typ.(2) Max. Units
VIH Input HIGH Voltage Guaranteed HIGH level 0.65 x VDD
VVIL Input LOW Voltage Guaranteed LOW level –0.5 0.35 x VDD
VIK Clamp Diode Voltage VDD = Max., IIN = –18mA –0.7 –1.2
IIH Input HIGH Current VDD = Max., VIN = VDD ±5 μA
IIL Input LOW Current VDD = Max., VIN = GND ±5
RON ON Resistance
VDD = Min., VIN = 1.3V, IIN =
40mA 10 Ohm
CON Capacitance ON (A/B) VIN = 0, VDD = 1.8V 3.5 pF
Power Supply Characteristics over 1.8V Operating Range (TA= -40°C to +85°C, VDD = 1.8V ±10%)
Parameters Description Test Conditions(1) Min. Typ.(2) Max. Units
IDD Quiescent Power Supply Current
VDD = 2.0, VIN and VSEL = GND or
VDD 300 400 μA
Notes:
1. For Max. or Min. conditions, use appropriate value specifi ed under Electrical Characteristics for the applicable device type.
2. Typical values are at VDD = 1.8V, TA = 25°C ambient and maximum loading.
Notes:
1. For Max. or Min. conditions, use appropriate value specifi ed under Electrical Characteristics for the applicable device type.
2. Typical values are at VDD = 1.8V, TA = 25°C ambient and maximum loading.
Notes:
1. For max. or min. conditions, use appropriate value specifi ed under Electrical Characteristics for the applicable device type.
Switching Characteristics over 1.8V Operating Range (TA= -40°C to +85°C, VDD = 1.8V ±10%)
Parameter Description(1) Min. Typ. Max. Units
tPZH, tPZL Line Enable Time - SEL to AN, BN0.5 8.0 ns
tPHZ, tPLZ Line Disable Time - SEL to AN, BN0.5 4.0
tb-b Bit-to-bit skew, within same differential pair 5
ps
tch-ch Channel-to-channel timing skew 12
tPD Propagation Delay, A to B or C / B or C to A 50 150