Raychem Circuit Protection RAYCHEM 308 Constitution Drive Menlo Park, CA 94025-1164 800-227-4856 FAX 800-227-4866 PRODUCT: AGR800S DOCUMENT: SCD 24645 PCN: 846426 REV LETTER: A REV DATE: NOVEMBER 2, 2000 PAGE NO.: 1 OF 2 Circuit Protection(R) PTC Devices Resettable Fuse Specification Status: RELEASED Electrical Rating Voltage: 16VDC MAX Insulating Material: Cured, Flame Retarded Epoxy Polymer Lead Material: 20 AWG Tin/Lead Plated Copper (0.8 mm [0.032] nom. diameter) Marking: Raychem Logo and Voltage 16 Part Identification G8 Lot Identification (can be on back) TABLE I. DIMENSIONS: mm:: in*: A B MIN MAX MIN MAX -12.7 16.0 20.9 -(0.50) 0.630 (0.820) *Rounded off approximation C MIN 4.3 (0.17) D MAX 5.8 (0.23) MIN 7.6 (0.30) E MAX --- MIN --- MAX 3.0 (0.12) F MIN 1.2 (0.05) G MIN --- MAX 5.08 (0.200) TABLE II. PERFORMANCE RATINGS: CURRENT RATINGS AMPS AT 25C HOLD HOLD TRIP AT AT R1 MAX RA MAX 8.0 7.6 15.0 Reference Documents: Precedence: Effectivity: CAUTION: TIME TO TRIP INITIAL RESISTANCE SECONDS AT 25C, 40 A MAX OHMS AT 25C MIN MAX 5.5 0.0049 0.0113 R1 MAX 1 HR. POST TRIP RESISTANCE STANDARD TRIP OHMS AT 25C RA MAX TRIPPED-STATE POWER DISSIPATION OHMS AT 25C WATTS AT 25C TYP 0.0175 0.0181 3.2 PS400, PS300 (reference for R1 MAX) This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 800-227-4856 FAX 800-227-4866 RAYCHEM Circuit Protection(R) PTC Devices Resettable Fuse PRODUCT: AGR800S DOCUMENT: SCD 24645 PCN: 846426 REV LETTER: A REV DATE: NOVEMBER 2, 2000 PAGE NO.: 2 OF 2 TABLE III. AUTOMOTIVE SPECIFIC STRESS TESTS AND TEST CONDITIONS: ELECTRICAL STRESS TESTS TEST CONDITIONS (see note 2) ESD Voltage Withstand (see note 1) Short Circuit Fault Current Durability 25kV Fault Current Durability 350 cycles, 16V/100A End-of-life Mode Verification 1750 cycles, 16V/100A Jump Start Endurance (see note 1) Load Dump Endurance (see note 1) 3 cycles, 26V, 1 minute duration 25 cycles, 16V, 200A 10 cycles, 86.5V Note 1: The PolySwitch devices are tested in series with a load resistance and the voltages specified in the test conditions are shared between the PolySwitch device and the load resistance as specified in PS400. Note 2: Please refer to Appendix A of PS400 for the detailed test procedures