AS1363 - Demo Board Manual
Low Dropout Regulator
www.austriamicrosystems.com Revision 1.00 1 - 5
Demo Board Manual
AS1363
500mA, Low-Dropout Linear Voltage Regulator
www.austriamicrosystems.com/LDO/AS1363
AS1363 - Demo Board Manual
Low Dropout Regulator
www.austriamicrosystems.com Revision 1.00 2 - 5
General Description
Board Description
Connector Description
Label Name Description Info
A VIN Supply Voltage
B GND Ground Supply voltage range from 2.0V to 5.5V
C EN Active High Enable Input Set the digital input “high” for normal operation. For
shutdown, set “low”
D VOUT Output Voltage Output voltage range from 1.2V to 4.5V (fixed)
Output voltage range from 1.2V to 5.3V (adjustable)
Measurement Point Description
Label Name Description Info
E VIN Supply Voltage
F GND Ground
G EN Active High Enable Input
H POK Open Drain POK Output
I BP BP (fixed Vout version)
J SET SET (adjustable Vout version)
K VOUT Output Voltage
Measurement Points
L Load External load
M EN Enable
ON: The AS1363 is enabled
OFF: The AS1363 is disabled
No Jumper: Connect a valid enable signal
via external connector “C”.
N R1
O R2 Resistor divider for adjustable
Vout version R1 between Vout and SET
R2 between SET and GND
Figure 1: Board Description
-
Connector
s
Figure 2
: Board Description
Measurement Points
A
E
C
B
D
A
C
B
D
G
F
H
J
K
L
I
N
O
M
AS1363 - Demo Board Manual
Low Dropout Regulator
www.austriamicrosystems.com Revision 1.00 3 - 5
Getting Started
The AS1363 Demoboard is designed to work with the AS1363 fixed output voltage version.
The AS1363 fixed Vout version is available with 1.5V, 1.8V, 3.0V, 3.3V and 4.5V.
The AS1363-AD Demoboard is designed to work with the AS1363 adjustable output voltage version.
The AS1363-AD adjustable Vout version has a valid Vout range from 1.2V to 5.3V. This Vout is adjustable via the
resistor divider R1/R2. A value for R2 in the range of 25k to 100k should be sufficient.
To use the factory preset Vout of 2.5V connect SET directly to GND (R1 = open; R2 = 0).
Bill of Materials
*) only for fixed Vout version
Ref. Function Value Description Manufacturer Mfg. Order Nr.
Cin Input Capacitor 1µF 1206 / X7R / 10V diverse
Cout Output Capacitor 2.2µF 1206 / X7R / 10V diverse
CBP* Bypass Capacitor 10nF 0805/X7R diverse
RPOK
POK pull-up resistor 100k 0805 diverse
U1 LDO ASRx SOT23-6pin Austriamicrosystems AG AS1363-BSTT-xx
AS1363 - Demo Board Manual
Low Dropout Regulator
www.austriamicrosystems.com Revision 1.00 4 - 5
Layout of Demo Board
Board schematics and layout
Figure 3: Schematics (fixed Vout)
Figure 4: Schematics (adjustable Vout)
Figure 5: Top + Bottom Layer (fixed Vout)
Figure 6: Top + Bottom Layer (adjustable Vout)
AS1363 - Demo Board Manual
Low Dropout Regulator
www.austriamicrosystems.com Revision 1.00 5 - 5
Copyright
Copyright © 1997-2010, austriamicrosystems AG, Tobelbaderstraße 30, 8141 Unterpremstätten - Graz, Austria -
Europe. Trademarks Registered ®. All rights reserved. The material herein may not be reproduced, adapted,
merged, translated, stored, or used without the prior written consent of the copyright owner.
All products and companies mentioned are trademarks or registered trademarks of their respective companies.
Disclaimer
Devices sold by austriamicrosystems AG are covered by the warranty and patent indemnification provisions
appearing in its Term of Sale. austriamicrosystems AG makes no warranty, express, statutory, implied, or by
description regarding the information set forth herein or regarding the freedom of the described devices from
patent infringement. Austriamicrosystems AG reserves the right to change specifications and prices at any time
and without notice. Therefore, prior to designing this product into a system, it is necessary to check with
austriamicrosystems AG for current information.
This product is intended for use in normal commercial applications. Applications requiring extended temperature
range, unusual environmental requirements, or high reliability applications, such as military, medical life-support
or life-sustaining equipment are specifically not recommended without additional processing by
austriamicrosystems AG for each application. For shipments of less than 100 parts the manufacturing flow might
show deviations from the standard production flow, such as test flow or test location.
The information furnished here by austriamicrosystems AG is believed to be correct and accurate. However,
austriamicrosystems AG shall not be liable to recipient or any third party for any damages, including but not
limited to personal injury, property damage, loss of profits, loss of use, interruption of business or indirect,
special, incidental or consequential damages, of any kind, in connection with or arising out of the furnishing,
performance or use of the technical data herein. No obligation or liability to recipient or any third party shall arise
or flow out of austriamicrosystems AG rendering of technical or other services.
Contact Information
Headquarters
austriamicrosystems AG
Tobelbaderstraße 30
A-8141 Unterpremstätten - Graz, Austria
T. +43 (0) 3136 500 0
F. +43 (0) 3136 5692
For Sales Offices, Distributors and Representatives, please visit:
http://www.austriamicrosystems.com/contact
Mouser Electronics
Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
ams:
AS1363-ST-18_EK_ST AS1363-ST-AD_EK_ST AS1363-ST-30_EK_ST