Amphenol(R) Assembly Instructions-C8 Type N CLAMP TYPES nut Amphenol Number washer A a B 1 male contact Cable RG-/U plug body Strip Dims., inches (mm) a c 18750 N Angle Plug 58, 141, 142 .484(12.3) .234(5.9) 34025 N Plug 58, 141, 142 .390(9.9) .203(5.2) 34025-RFX N Plug 58, 141, 142 .354(9.0) .177(4.5) 35275 N Bulkhead Jack 55, 58, 141, 142, 223 .561(14.3) .172(4.4) 36250 N Panel Jack 55, 58, 141, 142, 223 .375(9.5) .188(4.8) 82-63 N Jack 8, 9, 87A, 144, 165, 213, 214, 216, 225 .281(7.1) .156(4.0) 82-67 N Bulkhead Jack 8, 9, 87A, 144, 165, 213, 214, 216, 225 .281 (7.1) .156(4.0) 82-202 N Plug 8, 9, 144, 165, 213, 214, 216, 225 .359(9.1) .234(6.0) Belden 9913 .359(9.1) .234(6.0) .177(4.5) 82-202-RFX Step 1 clamp Connector Type 82-202-1006 N Plug gasket 8, 213, 214 .315(8.0) 82-209-1006 N Jack N Plug Belden 9913, Times AA-6146, 8 group .281(7.1) .156(4.0) 82-312 N Plug 8, 9, 144, 165, 213 .359(9.1) .234(5.9) 82-3202 N Plug 8, 9, 144, 165, 213 .270(6.9) .150(3.8) Not supplied with part number 36250 Step 1 Place nut, washer and gasket (with "V" groove toward open end of cable) over cable, and cut off jacket to dim. a. c C Step 2 Step 2 Comb out braid and fold out. Bare center conductor to dim. c as shown. 2 Step 3 P3 Step 3 Pull braid wires forward and taper toward center conductor. Place clamp over braid and push back against cable jacket. Step 4 solder SOLDER Step 4 Fold back braid wires as shown, trim braid to proper length and form over clamp as shown. Tin center conductor and solder on contact. P4 Step 5 STEP 5 Step 5 Insert cable and parts into connector body. Make sure sharp edge of clamp seats properly in gasket. Tighten nut. Amphenol Corporation Tel: 800-627-7100 www.amphenolrf.com 280