280
Amphenol Corporation Tel: 800-627-7100 www.amphenolrf.com
CLAMP TYPES
nut washer gasket▲clamp male contact plug body
Amphenol Connector Cable Strip Dims., inches (mm)
Number Type RG-/U
ac
18750 N Angle Plug 58, 141, 142 .484(12.3) .234(5.9)
34025 N Plug 58, 141, 142 .390(9.9) .203(5.2)
34025-RFX N Plug 58, 141, 142 .354(9.0) .177(4.5)
35275 N Bulkhead Jack 55, 58, 141, 142, 223 .561(14.3) .172(4.4)
36250 N Panel Jack 55, 58, 141, 142, 223 .375(9.5) .188(4.8)
82-63 N Jack 8, 9, 87A, 144, 165, 213, 214, 216, 225 .281(7.1) .156(4.0)
82-67 N Bulkhead Jack 8, 9, 87A, 144, 165, 213, 214, 216, 225 .281 (7.1) .156(4.0)
82-202 N Plug 8, 9, 144, 165, 213, 214, 216, 225 .359(9.1) .234(6.0)
82-202-1006 N Plug Belden 9913 .359(9.1) .234(6.0)
82-202-RFX N Plug 8, 213, 214 .315(8.0) .177(4.5)
82-209-1006 N Jack Belden 9913, Times AA-6146, 8 group .281(7.1) .156(4.0)
82-312 N Plug 8, 9, 144, 165, 213 .359(9.1) .234(5.9)
82-3202 N Plug 8, 9, 144, 165, 213 .270(6.9) .150(3.8)
Step 1 Place nut, washer and gasket (with "V" groove toward open
end of cable) over cable, and cut off jacket to dim. a.
Step 2 Comb out braid and fold out. Bare center conductor to
dim. cas shown.
Step 3 Pull braid wires forward and taper toward center conductor.
Place clamp over braid and push back against cable
jacket.
Step 4 Fold back braid wires as shown, trim braid to proper length
and form over clamp as shown. Tin center conductor and
solder on contact.
Step 5 Insert cable and parts into connector body. Make sure
sharp edge of clamp seats properly in gasket. Tighten nut.
Step 1
Step 2
Step 3
Step 4
Step 5
A
B
C
1
2
P 3
SOLDER
P
4
STEP 5
a
c
solder
Assembly Instructions-C8 Amphenol®
Type N
▲Not supplied with part number 36250
