V15
2
Specifications
TR30M Series Derating Curve
INPUT SPECIFICATIONS:
Voltage …....………........…........................................... 90~264Vac
Frequency ………………………………………….……………..... 47 to 63Hz
Inrush Current ………………….………….................... 50A max. @240Vac
Input Current ………………….……………..................................... 0.6A max.
OUTPUT SPECIFICATIONS:
Holdup Time ……………………………………………… 16ms typ. @115Vac
Short Circuit Protection …………….…………… Continuous(Auto Recovery)
Over Voltage Protection ………………............... TVS Component to Clamp
Temperature Coefficient ……………………............................… ±0.05%/℃
GENERAL SPECIFICATIONS:
NOTE:
Isolation …………………………………………… Input to output = 5,656VDC
1. Add a 0.1uF ceramic capacitor and a 10uF E.L. capacitor to output for
Operating Temperature ................................... 0 ~ 60℃(see derating curve)
Ripple & Noise measuring @20MHz BW.
Storage Temperature ……………………………...….......……........ -20~85℃
2. Voltage setpoint at 60% full load.
Humidity …………………...….......…......... . 93% RH max. Non condensing
3. Line regulation is measured from 100Vac to 240Vac with full load.
Cooling …………………………………………………….. Natural Convection
4. Load regulation is measured from 60% to full load and from 60% to
Switching Frequency ………………………………………….. 70KHz Typical
20% load (60% +/- 40% load).
MTBF ………..… MIL-HDBK-217F, GB, 25℃/115VAC ……. 300K hrs min.
5. Typical efficiency at 230VAC and full load at 25℃.
Altitude …………………………………………………………………… 3000m
6. ”Various TR Series adapters are PSE certified. PSE certification
Dimensions ……….. 4.331x1.969x1.181Inches (110.00x50.00x30.00mm)
alone is not sufficient for importation into Japan. A valid PSE mark
Weight ……………………………………………………… 220g(0.49 Pounds)
must contain the name of the importer as shown in the example below.
If PSE mark is required, the name of the registered importer must be
Emission and lmmunity …………..… EN55011, EN60601-1-2, EN61000-3-2
supplied to Cincon on order placement. Product labels will not contain
EN61000-3-3
PSE mark if importer name is not supplied. Consult factory or local
Safety ……….… IEC60601-1:2005, EN60601-1:2006, ANSI/AAMI ES60601-1:2005
representative for details”.
Mechanical Specification
DC Plug:Right Angle (ψ5.5 /ψ2.1)L12mm
18AWG / 1800mm
DC Plug type: V+ ─●)─ V-
LED
70.866[1800.00]±1.969[50.00]
IEC320/C8
1.969[50.00]
1.181[30.00]
4.331[110.00]
Tolerance:Inches:X.XXX±0.02
Millimeters:X.XX±0.5
All Dimensions are in inches(mm)
Typical at 25˚C, nominal line and 75% load, unless otherwise Specified
0%
20%
40%
60%
80%
100%
0 10 20 30 40 50 60
Ambient Temperature(
o
C)
Rated Load(%)
20LFM(Natural Convection)