4
Absolute Maximum Ratings Thermal Information
V+toV-........................................... 44V
V-toGround........................................ 25V
Digital Inputs, VS,V
D(Note1)............. (V--2V)To(V++2V)
Continuous Current, (Any Terminal Except S or D) . . . . . . . . . 30mA
ContinuousCurrent,(SorD)..........................20mA
Peak Current, S or D (Pulsed 1ms, 10% Duty Cycle Max). . . . . 40mA
Operating Conditions
Temperature Range
“A”Suffix................................-55
oCto125
oC
“B”Suffix.................................-25
oCto85
oC
“C”Suffix ................................. 0
oCto70
oC
Thermal Resistance (Typical, Note 2) θJA (oC/W) θJC (oC/W)
28LdCERDIPPackage............ 55 18
16LdPDIPPackage.............. 90 N/A
28LdPDIPPackage.............. 55 N/A
16LdSOICPackage.............. 100 N/A
28LdSOICPackage.............. 70 N/A
Maximum Junction Temperature
CERDIPPackage.................................175
oC
PDIPPackage...................................150
oC
Maximum Storage Temperature
“A”and“B”Suffix......................... -65
oCto150
oC
“C”Suffix ............................... -65
oCto125
oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . .300oC
(SOIC - Lead Tips Only)
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operationofthe
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. Signals on SX,D
X,E
N,orA
Xexceeding V+ or V- are clamped by internal diodes. Limit diode current to maximum current ratings.
2. θJA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications TA=25
oC, V+ = +15V, V- = -15V, GND = 0V, VEN = 2.4V, Unless Otherwise Specified
PARAMETER TEST CONDITIONS
“A” SUFFIX “B” AND “C” SUFFIX
UNITS
(NOTE4)
MIN (NOTE3)
TYP (NOTE4)
MAX (NOTE4)
MIN (NOTE3)
TYP (NOTE4)
MAX
DYNAMIC CHARACTERISTICS
Switching Time of
Multiplexer, tTRANSITION SeeFigure1 - 0.6 1 - 0.6 - µs
Break-Before-Make
Interval, tOPEN SeeFigure3 - 0.2 - - 0.2 - µs
Enable Turn-ON Time,
tON(EN) SeeFigure2 - 1 1.5 - 1 - µs
Enable Turn-OFF Time,
tOFF(EN) SeeFigure2 - 0.4 1.0 - 0.4 - µs
OFF Isolation, OIRR VEN =0V,R
L=1kΩ,C
L=15pF,
VS=7V
RMS, f = 500kHz (Note 5) -68- -68-dB
Source OFF Capacitance,
CS(OFF) VS=0V,V
EN = 0V, f = 140kHz
DG506A, DG507A - 6 - - 6 - pF
DG509A - 5 - - 5 - pF
Drain OFF Capacitance,
CD(OFF) VD=0V,V
EN = 0V, f = 140kHz
DG506A - 45 - - 45 - pF
DG507A - 23 - - 23 - pF
DG509A - 12 - - 12 - pF
Charge Injection, Q See Figure 4
DG506A, DG507A - 6 - - 6 - pC
DG509A - 4 - - 4 - pC
DIGITAL INPUT CHARACTERISTICS
Address Input Current,
Input Voltage High, IAH VA= 2.4V -10 -0.002 - -10 -0.002 - µA
VA= 15V - 0.006 10 - 0.006 10 µA
Address Input Current
Input Voltage Low, IAL VEN =2.4V V
A= 0V -10 -0.002 - -10 -0.002 - µA
VEN = 0V -10 -0.002 - -10 -0.0002 - µA
DG506A, DG507A, DG509A