SPEC NO: DSAC1836 REV NO: V.7 DATE: AUG/22/2005 PAGE: 1 OF 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG
SURFACE MOUNT DISPLAY
Package Dimensions & Internal Circuit Diagram
Notes:
1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted.
2. Specifications are subject to change without notice.
Description
The Hyper Red source color devices are made with DH
InGaAlP on GaAs substrate Light Emitting Diode.
KPSC03-105 HYPER RED
Features
0.3 INCH DIGIT HEIGHT.
LOW CURRENT OPERATION.
EXCELLENT CHARACTER APPEARANCE.
I.C. COMPATIBLE.
MECHANICALLY RUGGED.
GRAY FACE,WHITE SEGMENT.
PACKAGE : 550PCS / REEL.
RoHS COMPLIANT.
SPEC NO: DSAC1836 REV NO: V.7 DATE: AUG/22/2005 PAGE: 2 OF 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG
Selection Guide
Part No. Dice Lens Type Iv (ucd)
@ 10 mA
Min. Typ.
KPSC03-105 HYPER RED (InGaAlP) WHITE DIFFUSED 3000 15257 Common Cathode, Rt.
Hand Decimal.
Description
Electrical / Optical Characteristics at TA=25°C
Absolute Maximum Ratings at TA=25°C
Note:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
Parameter Hyper Red Units
Power dissipation 75 mW
DC Forward Current 30 mA
Peak Forward Current [1] 185 mA
Reverse Voltage 5 V
Operating/Storage Temperature -40°C To +85°C
Symbol Parameter Device Typ. Max. Test ConditionsUnits
λpeak Peak Wavelength Hyper Red 650 nm IF=20mA
λDDominant Wavelength Hyper Red 635 nm IF=20mA
∆λ1/2 Spectral Line Half-width Hyper Red 28 nm IF=20mA
C Capacitance Hyper Red 35 pF VF=0V;f=1MHz
VFForward Voltage Hyper Red 1.95 2.5 V IF=20mA
IRReverse Current Hyper Red 10 uA VR = 5V
SPEC NO: DSAC1836 REV NO: V.7 DATE: AUG/22/2005 PAGE: 3 OF 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG
Hyper Red KPSC03-105
SPEC NO: DSAC1836 REV NO: V.7 DATE: AUG/22/2005 PAGE: 4 OF 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG
KPSC03-105
Recommended Soldering Pattern
(Units : mm)
Remarks:
If special sorting is required (e.g. binning based on forward voltage, Luminous intensity/ luminous flux, or wavelength),
the typical accuracy of the sorting process is as follows:
1. Wavelength: +/-1nm
2. Luminous intensity/ luminous flux: +/-15%
3. Forward Voltage: +/-0.1V
Note: Accuracy may depend on the sorting parameters.
Tape Specifications
(Units : mm)
