58mm (2.3 INCH) 8x8 DOT MATRIX DISPLAY P/N: TA23-11YWA YELLOW Features Description *2.3 INCH MATRIX HEIGHT. The Yellow source color devices are made with Gallium *DOT SIZE 5mm. Arsenide Phosphide on Gallium Phosphide Yellow Light *LOW CURRENT OPERATION. Emitting Diode. *HIGH CONTRAST AND LIGHT OUTPUT. *COMPATIBLE WITH ASCII AND EBCDIC CODES. *STACKABLE HORIZONTALLY. *COLUMN CATHODE AND COLUMN ANODE AVAILABLE. *EASY MOUNTING ON P.C. BOARDS OR SOCKETS. *MULTICOLOR AVAILABLE. *MECHANICALLY RUGGED. *STANDARD : GRAY FACE, WHITE DOT. *RoHS COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAD2459 REV NO: V.6 DATE: NOV/29/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG ERP:1332000192 Selection Guide Part No. Dice TA23-11YWA Lens Type YELLOW (GaAsP/GaP) WHITE DIFFUSED Iv (ucd) @ 10mA Description Min. Typ. 1900 8000 Column Anode Electrical / Optical Characteristics at TA=25C Symbol Parameter Device peak Peak Wavelength Yellow D Dominant Wavelength 1/2 Typ. Max. Units Test Conditions 590 nm IF=20mA Yellow 588 nm IF=20mA Spectral Line Half-width Yellow 35 nm IF=20mA C Capacitance Yellow 20 pF VF=0V;f=1MHz VF Forward Voltage Yellow 2.1 2.5 V IF=20mA IR Reverse Current Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25C Parameter Yellow Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating/Storage Temperature -40C To +85C Lead Solder Temperature [2] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. SPEC NO: DSAD2459 REV NO: V.6 DATE: NOV/29/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG ERP:1332000192 Yellow TA23-11YWA SPEC NO: DSAD2459 REV NO: V.6 DATE: NOV/29/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG ERP:1332000192 PACKING & LABEL SPECIFICATIONS TA23-11YWA Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity/ luminous flux or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity/ Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD2459 REV NO: V.6 DATE: NOV/29/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.W.WANG ERP:1332000192