4915 W alnut Grove A ve. San Gabriel, CA 91776 Tel. 626-287-0451 F ax 626-287-7350
E-mail: sales@calmark.com tech@calmark.com Website: http://www.calmark.com
Unit: INCH (MM)
58
CORPORATION
series 107-50 inserter - extractor (“ultra strong”)
Calmark offers the Series 107-50 Card Inserter-Extractor for safe and easy insertion and extraction of PC cards in the severest
applications of high insertion and extraction forces.
FEATURES:
• “Ultra strong” lever action design overcomes insertion and
extraction forces of highest possible limits.
• Narrow width -- .290 inches (7.37).
• Actuates from a simple “U” channel form.
• Mounting detail on card retrofits other industry standards.
• No chamfer required on corner of card.
TABULATION
Nominal position of card edge
when seated in connector.
The Inserter-Extractor will
allow .05 (1.3) over-travel
for tolerance take-up.
DET AIL OF ACTUA TING SURFACES
Required on top and bottom guide
plates of Calmark fabricated card
cages.
.24 Min.
(6.1)
.06 Max. (1.5)
Card
Guide
Surface
0.06 Ref.
(1.5)
.285 +/- .015
(7.24 +/- 0.38) .36 (9.1)
Card Clearance
required when
rotated.
.73
(18.5)
Assembly Pin
(furnished) .250
(6.35)
.475
(12.06)
2.00
(50.8)
.290
(7.37)
.156 R
(3.96)
.500 (12.70)
.109 Dia. Hole
(2.77)
.250
(6.35)
.ONTRAP draC ssenkcihT
05-701)6.1("61/1
3-05-701)4.2("23/3
4-05-701)2.3("8/1
Extractor - Aluminum alloy 6061-T6.
Black Anodize per MIL-A-8625, Type II, Class 2.
For Conductive Finish, add prefix “C” to part number (C107-50).
Clear chemical film per MIL-5541, Cl 3.
Roll Pin: Stainless Steel, 3/32” (2.38)dia. x 1/4” (6.4) long.
Furnished with each inserter-extractor.
For Pre-Started Assembly Pin, add prefix “P” to part number (P107-50)
TOLERANCES: .xxx = +/- .010, .xx = +/- .02
(.xx=+/- 0.25, .x=+/- 0.5)
APPLICATION DATA:
Two inserter-extractors are required per board.
Provides insertion and extraction travel of .35(8.9)
minmum with a mechanical advantage of
approximately 4.5 : 1.
MATERIALS & FINISH
